Berkley Jensen 185650 User manual

Pistol Drill Tape Measure Hammer Screwdriver Ladder 5 people
Note: The gazebo needs to be installed in cooperation with five people.
The following tools are not included and needed for assembly:
10’x12’
HARDTOP GAZEBO
WITH CEDAR WOOD POST
ARTICLE# 185650
If you have comments or questions, please contact BJ’s Wholesale Club at 1-800-934-1204.
If you have any issues with the product, do not return the product back to the store.
For any questions, replacement parts or issues about our product, call Sunjoy Customer
Service 1(866) 578 6569. For further assistance, please email us at [e-mail].
ASSEMBLY INSTRUCTIONS

Warning! To reduce the risk of serious injury, read the following safety instructions before
assembling and using the gazebo.
Caution! Always keep children under close supervision while they are using or around this product.
Never leave children unattended.
This product is intended for outdoor use only.
The product should be assembled on a flat stable surface.
Do not assemble the gazebo on unstable surfaces.
Ensure the location and clearance of your gazebo is acceptable.
The gazebo must be anchored with stakes into the ground for added safety. It is recommended
that it should not be permanently attached to a concrete floor or platform.
Arrange the necessary manpower when assembling or moving the product.
Some parts may contain sharp edges. Wear protective gloves and glasses if necessary.
Keep children and pets away while setting up the gazebo.
Check all nuts and bolts periodically for tightness. When required, tighten them again.
Repairing and replacing parts should be done by a qualified technician.
Remove all excess snow from the roof.
If the product is not being used for long periods of time (e.g. winter), it should be stored in a clean,
dry environment.
Do not put a Liquid Propane or Wood Burning fire pit or fireplace inside the product.
Do not climb or place heavy objects onto the gazebo roof.
Retain the original packaging to store and protect the gazebo during the winter months.
Do not use or enter the gazebo if the following conditions exists：
1. Visible movement of supports, roofing panels or a sagging roof.
2. Unusual noise from the gazebo.
3. Deformed roof panels.
4. Damaged or missing bolts/fasteners.
Please check your HOA, Local, and State Governments prior to purchasing and assembling
gazebos. These local organizations may require permits and specific requirements for
installation.
Maintain your instruction manual for future reference
Warranty: Please retain you receipt for proof of purchase.
Important Safety Instructions

Description Label Part Number Qty Part Image
Long left beam 01 P000401052 2
Long right beam 02 P000401054 2
Short left beam 03 P000401056 2
Short right beam 04 P000401058 2
Long beam 05 P000401060 4
Short beam 1 06 P000401049 4
Short beam 2 07 P000401050 4
Post 08 P000200544 4
Base cover 09 P006100201 16
Arc support 1 10 P005000525 4
Arc support 2 11 P005000526 4
Big top frame A1 P00050057901 2
Big top bar B1 P00050058001 2
Small top
support C1 P00060069601 4
Beam Small top
connector D1 P00060069501 1
Hook E1 P005800001 1
Top roof small
panel 1 F1 P00070024801 2
Top roof small
panel 2 G1 P00070024901 2
Part List

Small top cover H1 P00080011501 4
Small top roof
cover I1 P00080011401 1
Base E2 P00010014301 4
Slanting bar
connector F2 P00050058101 4
Middle beam
connector G2 P00050058201 4
Long pipe 1 R2a P00570020301 2
Long pipe 2 R2b P00570020401 2
Short pipe 1 S2a P00570020501 2
Short pipe 2 S2b P00570020601 2
Top slanting bar P3 P00060069801 4
Big top middle
beam B3 P00060069701 4
Long side left roof
panel 1 C3 P00070025901 2
Long side right roof
panel 1 D3 P00070026001 2
Long side left roof
panel 2 E3 P00070025701 2
Long side right roof
panel 2 F3 P00070025801 2
Long side left roof
panel 3 G3 P00070025501 2
Long side right roof
panel 3 H3 P00070025601 2
Short side roof
panel I3 P00070025001 2

Short side left roof
panel 1 J3 P00070025101 2
Short side right roof
panel 2 K3 P00070025201 2
Short side left roof
panel 2 L3 P00070025301 2
Short side right roof
panel 3 M3 P00070025401 2
Big roof panel
cover N3 P00080011601 4
Top slanting bar O3 P00080011701 4
Big roof top beam
(short side) 1 W1 P00060069901 4
Big roof top beam
(short side) 2 W3 P00060070001 4
Big roof top beam
(short side) 3 W5 P00060070101 4
Big roof top beam
(long side) 1 X1 P00060070201 4
Big roof top beam
(long side) 2 X3 P00060070301 4
Big roof top beam
(long side) 3 X5 P00060070401 4

AA Bolt M10*205 H010010276 8
BB Flat Washer M6 H050030001 198
CC Screw M5*35 H030050037 128
DD Nut M6 H040010004 12
EE Screw M5*25 H030050036 64
FF Bolt M6*15 H010020011 148
GG Bolt M6* 45 H010020016 16
HH Bolt M8*35 H010030083 16
II Bolt M8*35 H030030010 16
JJ Bolt M6*55 H010020009 14
KK Bolt M8*25 H010030084 24
LL Non-slip Nuts
M10 H040050020 8
Hardware Pack

MM Flat Washer M8 H050030002 56
NN Flat Washer
M10 H050030003 24
OO Screw M10*80 H030010031 8
PP Stake Φ8*180 H070010003 8
QQ Bolt M6*35 H010020013 8
RR M3 Drill H090990002 2
SS T-Nut
M8*20 H040090005 16
VV T-Nut
M8*8 H040090004 24
Z1 Wrench M6 H090010017 2
Z2 Allen Key M8 H090030005 1
Z4 Wrench M10 H090010015 2

1
4
x
4
x
16
x
Install the post base.

2
4X
4X
4X
16X
16X
16X
16X
4X
Connect the Long beam to short beam.

3
2X
2X
2X
8X
8X
8X
2X
4X
Install the Long Beam & Short Beam.

4
64X
Tighten the Screw.

5
16X
4X
Install the Middle beam connector.

6
2x
4x
4x
4
x
12
x
Connect the Beam to the post.

7
2x
12
x
4x
32x
4
x
4
x
4x
Connect the Beam to the post.

8
4
x
4x
16x
16x
32x
d
1=d2
Assembly Tip:
We advise to measure the distance between d1
& d2 to ensure that they are equal in distance.
In addition, best to use a Bubble Level Gauge”
to ensure all the posts are upright.
Rt
∠
90
Install the Arc support.

9
2x
2x
4x
4x
Connect the Big top frame to Big top bar.

10
4x
16x
16x
Install the Top slanting bar.

11
4x
8x
24x
8x
8x
Install the Big top middle beam.

12
4x
1x
4
x
8x
4x
1x
Install the Small top support (C1) & Beam Small top connector (D1) & Hook(E1).

13
4x
4x
1x
Connect the Installed 12 step to roof.