Berkley Jensen 280154 User manual

12’X10’
STEEL PERGOLA
ASSEMBLY INSTRUCTIONS
Note: The pergola needs to be installed in cooperation with five people.
The following tools are not included and needed for assembly:
If you have comments or questions, please contact BJ’s Wholesale Club at 1-800-934-1204.
Carefully check all packaging materials before discarding.
Make sure you have all the parts and hardware as identified on the parts list.
Do not assemble if there are missing pieces.
For any questions, replacement parts or issues about our product,
contact Sunjoy Customer Service at 1-866-578-6569 or email [email protected].
Drill Tape Measure Hammer Screwdriver Ladder 5 people
ARTICLE# 2 80154

2/ 18
Warning! To reduce the risk of serious injury, read the following safety instructions before assembling
and using the pergola.
Caution! Always keep children under close supervision while they are using or around this product.
Never leave children unattended.
This product is intended for outdoor use only.
The product should be assembled on a flat stable surface.
Do not assemble the pergola on unstable surfaces.
Ensure the location and clearance of your pergola is acceptable.
The pergola must be anchored with stakes into the ground for added safety. It is recommended that
it should not be permanently attached to a concrete floor or platform.
Arrange the necessary manpower when assembling or moving the product.
Some parts may contain sharp edges. Wear protective gloves and glasses if necessary.
Keep children and pets away while setting up the pergola.
Check all nuts and bolts periodically for tightness. When required, tighten them again.
Repairing and replacing parts should be done by a qualified technician.
The pergola is intended for decorative and shade purpose, please remove the canopy during rain,
wind or snowy conditions.
If the product is not being used for long periods of time (e.g. winter), it should be stored in a clean,
dry environment.
Do not put a Liquid Propane or Wood Burning fire pit or fireplace inside the product.
Do not climb or place heavy objects onto the pergola roof.
Retain the original packaging to store and protect the pergola during the winter months.
Do not use or enter the pergola if the following conditions exists：
1. Visible movement of supports, roofing panels or a sagging roof.
2. Unusual noise from the pergola.
3. Deformed roof panels.
4. Damaged or missing bolts/fasteners.
Please check your HOA, Local, and State Governments prior to purchasing and assembling
pergolas. These local organizations may require permits and specific requirements for installation.
Maintain your instruction manual for future reference
Warranty: Please retain you receipt for proof of purchase.
I
mportant Safety Instructions
EXPLODED DRAWING

3/ 18

4/ 18
Label Description Part Number Qty Part Image
A Post 1 P00020072301 2
B Post 2 P00020072401 2
C Post Base P00010048301 4
D Post Cover P00610024101 4
E Cross Beam 1 P00040135501 2
F Cross Beam 2 P00040135601 2
G Top Arc Beam 1 P00060229201 2
J Top Arc Beam 2 P00060229301 2
K Connector P00050173201 2
L Brace 1 P00500068301 4
M Brace 2 P00500068401 4
N Top Beam 1 P00060229401 9
P Top Beam 2 P00060229501 9
Q Fabric Rod 1 P00570087301 2
R Fabric Rod 2 P00570087401 2
S Canopy P00640000101 1
T Rail Rod P00570087501 4
U
Rail Rod
Connector P000501518 8
Part List

5/ 18
Label Description Part Number Qty Part Image
H1 Bolt M6*12 H100010147 4+1
H2 Bolt M6*20 H100010047 40+2
H3 Bolt M6*20 H100010050 18+1
H4 Bolt M6*55 H100010051 58+3
H5 Bolt M6*75 H100010074 8+1
HS Stake Φ8*180 H070010001 8
HW1 Allen Key M6 H090030002 1
HW2 Wrench M6 H090010017 1
Hardware Pack

6/ 18
1
Install the post base.

7/ 18
2
Install the Cross Beam.

8/ 18
3
Connect the Cross Beam to post.

9/ 18
4
Install the Top Arc Beam.

10 / 18
5
d1=d2
Rt
∠
90
Connect the Top Arc Beam to the post.

11 / 18
6
Install the Brace.

12 / 18
7
Install the Top Beam.

13 / 18
8
Install the Top Beam.

14 / 18
9
Install the Fabric Rod.

15 / 18
10
Install the Canopy.

16 / 18
11
Install the Rail Rod.

17 / 18
12
Secure the assembled pergola to the lawn with the stakes (HS).

18 / 18
Caution!
Check all screws and nuts periodically for tightness, fastening them again as required.
Disassemble the pergola in the reverse order of the assembly steps. Always disassemble the
pergola completely. A partially disassembled pergola is not stable enough to resist wind and bad
weather, and therefore can be damaged and/or cause damage.
Clean the pergola with mild soap and water. Rinse thoroughly，and wait until the product is dry
before reassembling it.
The pergola is intended for decorative and shade purpose, please remove the canopy during rain,
wind or snowy conditions Do not use bleach, acid, or other abrasive cleaners on the canopies or
frame parts.
Keep instruction manual for future reference.
Keep the original packaging to store the pergola.
Carefully check all packaging materials before discarding. Do not assemble if there are missing pieces.
For comments or questions please contact BJ’s Wholesale Club at 1-800-934-1204.
Please do not return this product to the store. For technical assistance on assembly or replacement parts
call Sunjoy Group at 1(866) 578-6569 anytime 24 hour /7 days a week or Email [e-mail] or
visit www.sunjoyonline.com to place your order or fax your parts replacement order form together with
your purchase receipt to 951-667-3447 for assistance.
Cleaning and Maintenance
Warranty