Bernini 2-in-1 Hummingbird & Bird Seed Feeder User manual

|1
CONTENTS:
ASSEMBLY:
PLEASE READ THESE INSTRUCTIONS COMPLETELY
BEFORE ATTEMPTING TO ASSEMBLE YOUR NEW
2-IN-1 HUMMINGBIRD & BIRD SEED FEEDER
Flower Port Cover
Hummingbird Perch Ring
& Food Dish
Please note, images of parts are not to scale with one another.
Hummingbird Food/Water
Reservoir
Upper Bird Feeder Assembly
Pre Assembly Preparation:
1. Note: The 2-in-1 Hummingbird & Bird Seed Feeder is designed for easy assembly but please use
caution when assembling.
2. Prior to assembly take time to nd a suitable location for your 2-in-1 Hummingbird & Bird Seed
Feeder and make sure to assemble your new 2-in-1 Hummingbird & Bird Seed Feeder on spacious
and clean work surface.
3. Use Diagram 1 for reference on part names, assembly and how all the individual parts t together.
4. Observe all safety precautions.
2-in-1 Hummingbird & Bird Seed Feeder Owners Manual
Assembling The Lower Bird Feeder Assembly:
1. On a at even surface place the Hummingbird Food/Water Reservoir with the open end
facing up, ll with your choice of hummingbird food/water (see recommendation later in this
instruction) approximately 80% full (Figure 1 & Figure 1 arrow).
2. Set the Hummingbird Food Dish/Perch Ring upside down on the Hummingbird Food/Water
Reservoir and screw onto the Hummingbird Food/Water Reservoir. Screw past the threads
and then push onto the rib to hold Hummingbird Food/Water Reservoir in place (Figure 2).
3. Take the Hummingbird Food Dish/Perch Ring turn it upside down and screw onto the Hum-
mingbird Food Reservoir snug but DO NOT OVER TIGHTEN (Figure 3 & 4).
4. Flip the assembled Hummingbird Food Reservoir/Hummingbird Food Dish/Perch Ring over
(Figure 5). The Hummingbird Food Dish will gravity feed/ll from the reservoir until an equilibri-
um is achieved.
5. Push down the Flower Cover Port till it is free from the rib (Figure 6 small black arrow),
Thread and tighten the Flower Cover Port until snug against the Hummingbird Food Dish/
Perch Ring but DO NOT OVER TIGHTEN (Figure 7).
Assembling The Upper Bird Feeder Assembly:
5. The Upper Bird Feeder Assembly comes pre-assembled. Set the Upper Bird Feeder As-
sembly Bird Perch Ring on a at surface (Figure 7 arrow), press the Lock Button and pull up
to the Hanging Loop Lock Ring, this will allow you to lift up the Bird Seed Fill Cover. (Figure 8).
Set the Bird Seed Fill Cover to the side of the Upper Bird Feeder Assembly.
6. Fill with your choice of bird seed (see recommendations later in this instruction). Fill approx-
imately 80% (Figure 9 Black arrows).
7. Put the Bird Seed Fill Cover back onto the top of the Bird Seed Reservoir (Figure 10), press
the Lock button and pull up on the Hanging Cable to tighten (Figure 11).
Hummingbird
Food Dish
Hummingbird
Perch Ring
Flower Cover
Port
Ribs
Hummingbird
Food/Water
Reservoir
LOWER BIRD FEEDER
ASSEMBLY
Bird Perch
Ring
Diagram 1:
Bird Seed
Reservoir
Bird Seed
Food Dish
Bird Seed
Fill Cover
Hanging
Cable
Lock
Button
UPPER BIRD FEEDER
ASSEMBLY
Hanging Hoop
Lock Ring
Hanging
Hoop

2|
Mounting: Hang your 2-in-1 Humming-
bird & Bird Seed Feeder with a hook or
chain or mount it on a bird feeder pole.
What to oer: Consider using food like
seed, mealworms, suet or fruit to attract
a variety of bird species.
When to feed: Feeding year round is
good for the birds and gives you year
round enjoyment.
Water: Provide Birds with a regular
supply of water for both drinking and
bathing.
TIPS & TRICKS:
Figure 14 Figure 15
ASSEMBLY: (CONTINUED)
Figure 1
Figure 5
Figure 10
Figure 4
Figure 9
Figure 13
Figure 2
Figure 6
Figure 11
Figure 3
Figure 8Figure 7
Figure 12
Assembling The Upper Bird Feeder Assembly: (continued)
8. The Upper Bird Feeder Assembly screws into the Lower Bird Feeder Assembly. Set The Upper Bird Feeder Assembly on top of the Lower Bird Feeder
Assembly (Figure 13).
9. Screw the Upper Bird Feeder Assembly by turning the bird perch ring onto the Lower Bird Feeder Assembly (Figure 14). Ensure it is snug but DO NOT
OVER TIGHTEN. If upper bird assembly will not screw in, check to make sure cable from the upper bird assembly is not in the way, if so you will need to
tighten the cable.
10. Hang your new
2-in1 Hummingbird Bird Seed Feeder in your choice of locations (see recommendations later in this instruction). Enjoy!

|3
The Bernini 2-in1 Hummingbird Bird Seed Feeder can be disassembled for easy cleaning or replacing parts.
Cleaning your 2-in1 Hummingbird Bird Seed Feeder
For healthy and happy birds and in order to keep your 2-in1 Hummingbird Bird Seed Feeder in tip-top shape and free
of bacteria, we recommend cleaning your 2-in1 Hummingbird Bird Seed Feeder once a month in winter, more frequent
in hot and humid weather. Cleanings provide a healthy and happy environment for all the birds visiting your 2-in1 Hum-
mingbird Bird Seed Feeder, and this will provide may hours of enjoyment for you and your birds. To clean your 2-in1
Hummingbird Bird Seed Feeder fully disassemble and use a mild soap and soft cloth to clean the parts. Make sure to
rinse thoroughly after any and all cleaning.
DO NOT SCRUB YOUR 2-IN1 HUMMINGBIRD BIRD SEED FEEDER USING COARSE OR HARSH CLEANSERS OR
SCRUBBING PADS AS THIS COULD CAUSE DAMAGE TO THE FINISH.
Cleaning Plastic Components
1. Allow the birds to empty the 2-in1 Hummingbird Bird Seed Feeder as far as possible. Empty out any remaining seed
and debris.
2. Disassemble the 2-in1 Hummingbird Bird Seed Feeder.
3. Carefully remove any surface debris with a soft wet sponge or cloth. Using a dry sponge or cloth will scratch the sur-
face.
4. Use a soft brush (non-abrasive) or soft cloth, and a solution of a mild hand dish washing detergent and warm water to
remove dust, salt and other contaminates.
5. We recommend disinfecting the polycarbonate components of your 2-in1 Hummingbird Bird Seed Feeder using a
50/50 solution of white vinegar and warm water, rinse thoroughly.
6. Ensure to dry all components of the 2-in1 Hummingbird Bird Seed Feeder completely before reassembly and lling the
feeder with seed.
Cleaning The Bronze Colored Metal Components
Proper cleaning will help protect the powder coated nish from the eects of water, sun and pollution. Maintaining the
nish on powder coated components is essential to protecting your 2-in1 Hummingbird Bird Seed Feeder. Powder coat-
ing is a very durable, protective coating for metal surfaces, but proper care will help prolong the nish. Over time, pow-
der coated nishes exposed to the elements may show signs of weathering such as reduced gloss, chalking and slight
color loss. Consistent, scheduled cleanings will help remove dirt, grime and other surface buildup that may be harmful to
the powder coated nish.
1. Carefully remove any loose surface debris with a soft wet sponge or cloth. Using a dry sponge or cloth will scratch the
surface.
2. Use a soft brush (non-abrasive) or soft cloth, and a solution of a mild hand dish washing detergent and warm water to
remove dust, salt and other deposits.
3. Do not use a solution of white vinegar and water on the powder coated metal components as this may damage the
nish.
4. Dry all components completely before reassembly and lling your 2-in1 Hummingbird Bird Seed Feeder with seed.
5. Powder coated components only! Extra protection may be required to prolong the nish, especially in harsh environ-
ments. Use a light coat of high grade, nonabrasive car wax containing UV blocker and/or UV inhibitors on the surfaces
which are only exposed to the elements. Wipe o any residual wax as this may cause permanent staining from the heat
of the sun. If used clean and or remove any harsh chemicals prior to lling with any bird seed or hummingbird food as
this may harm birds.
Placement: Birds feel vulnerable out in the open so we recommend you place your 2 in 1 Hummingbird Bird Seed
Feeder near a tree or bush but not too close where a squirrel could jump in. Birds are creatures of habit and it could take
weeks to feel comfortable at a new feeder.
With options of hanging or pole mounting, you can have your 2-in-1 Hummingbird & Bird Seed Feeder almost anywhere!
Place your 2-in1 Hummingbird Bird Seed Feeder where you can easily see it, even an accessible second story window!
If you must place a nectar feeder in full sun for your enjoyment, just remember to check the condition of the nectar more
often. In order to help hummingbirds nd your feeders more easily, place them near a hanging owering plant or tie a red
ribbon around the hanging rod. If you place your 2-in1 Hummingbird Bird Seed Feeder out in early spring, you will be
able to entice the early arrivals of spring migration and persuade them to stay.
CLEANING, CARE AND MAINTENANCE:
MAXIMIZE YOUR BACKYARD BIRD EXPERIENCE:

4|
Santee, California 92071 | World Wide Patents Pending | Email: [email protected] | On the web: www.berninifountains.com
Facebook & Pinterest: Bernini Fountain Company | Instagram: @berninifountains Twitter: @yrdllc
© Yeiser Research & Development, LLC; 2020. All rights reserved.
Made in China | Designed in the USA
001214 B2I1HBSFI rev 1g US
Please read rst before returning:
Please call us for assistance at [phone] or email us at [e-mail]. Our Customer
Care Department is available: Monday - Friday 8:30am to 4:00pm PST, 11:30am to 7:00pm EST. If you have any ques-
tions regarding assembly, parts or operation, please visit our website at www.berninifountains.com. On our website, you
will nd instructional videos on how to assemble and operate your 2-in-1 Hummingbird & Bird Seed Feeder and you can
keep up to date on our newest products. This product comes with a one year limited warranty against materials and
workmanship.
Call us for assistance at [phone] or you can email us at [e-mail] or mail us at:
9545 Pathway Street, Santee, CA 92071, Our Customer Care Department is available: Monday - Friday 8:30am to
4:00pm PST /11:30am - 7:00pm EST
LIMITED ONE YEAR WARRANTY
This warranty gives you specic legal rights and you may also have other rights which vary from state to state. This
product has a one year limited warranty on all materials and workmanship. Bernini® warrants the original purchaser of
this product that the product will be free from manufacturing defects in workmanship and material for a period of one (1)
year from the date of original purchase. If within one (1) year this product fails due to defect in material or workmanship,
Bernini® will repair, replace or supply any defective part(s) at their discretion. The purchaser must contact Bernini® and
provide a description of the defective part, including digital pictures if requested, with this original purchase documen-
tation as validation of warranty coverage. This warranty does not cover or apply to: (a) damage to the product due to
misuse, mishandling, and abuse, (b) products not used in accordance with instructions, (c) product not assembled or
installed according to instructions, and (d) normal wear and tear.
NECTAR NEEDS
Hummingbirds need to feed between 5 and 8 times every hour, so keeping your feeder well supplied with energy packed
nectar is crucial, especially in early spring when natural ower nectar and insects are not as readily available.
Hummingbird Nectar Recipe
The formula for hummingbird food is simple: about one part white granulated sugar to four parts water. Boil the water
for approximately 2 minutes, add the sugar, and stir to dissolve thoroughly. We do not recommend adding red dye to the
nectar mixture. Cover and allow to cool before using or pouring into a clean storage bottle. A large batch of nectar can
be made and stored in the refrigerator for up to two weeks. This makes relling the feeder easy so you won’t mind doing
it every few days.
You must change the nectar frequently - at least twice a week. The need to change the nectar depends on the tempera-
tures, where the feeder is hung, and number and frequency of hummingbirds feeding at your feeder. If the birds are not
emptying your feeder between cleanings, it’s unnecessary and wasteful to ll it completely. Fill only with the amount
of nectar they will consume in a few days. Over time you will get a feel for how much nectar to put in the feeder. If you
notice that the nectar is turning milky, or that white strings or black spots are growing in it, change it more often. If you
don’t have hummingbirds in your area you can ll the hummingbird feeder (Lower Bird Feeder Assembly) with water.
BIRD NEEDS
What type of seed/feed?
While birds sometimes surprise us with their seed/food choices, the seed listed below typically attract these birds:
Mixed seeds: Cardinals, Grosbeaks, Titmice, Nuthatches, Chickadees, Finches, Jays, Juncos
Sunower: Cardinals, Grosbeaks, Titmice, Nuthatches, Chickadees, Juncos
Thistle (Nyger): Finches, Siskins
Suet Cake: Woodpeckers, Jays, Titmice, Chickadees, Nuthatches
Nectar: Hummingbirds, Orioles
Grape Jelly/Orange halves: Orioles
Mealworms: Bluebirds, Wrens, Chickadees
Peanuts: Jays, Woodpeckers
Chopped apples/dried fruit: Woodpeckers, Mockingbirds, Catbirds, Robins
HELPFUL TIPS: