BESTE X9 User manual

Electric Scooter X9
User Manual

To ensure safe use, please read the instruction manual carefully.
This instruction manual contains important safety information and tips,
please read it carefully. Do not use the electric scooter before you read
it. Keep the instruction manual properly.

About the manual
● Congratulations on your purchase of the E-scooter.
● For your driving Safety, please read this user manual carefully before using and ensure to
be able to ride the scooter under correct guidance. Learning all the safety warning and
tips listed in this manual that will be helpful for you to better control the scooter.
● Should you have any inquiries, please contact the supplier immediately.
Tips:
1. Children below 14 years old shall be accompanied by an adult.
2. The people without experience, poor ability to accept & physical coordination, should
learn to ride with accompanies. Please read this manual carefully before you ride the
electric scooter, make sure that you can riding with correct guide.
3. No parents Accompanied, children are prohibited from cleaning and maintenance of
the product.
Please turn off the power after using the scooter to prevent the scooter starting due to
accidental touching the accelerator.
WARNING!
Improper use of the scooter and/or failure to read this user manual may lead to serious
bodily injury. Seller will take no responsibility for any injuries caused by improper
use without following the manual.
Content
1. Packing list........................................................................................................... 2
2. Product Introduction...........................................................................................3-4
3. Product assembly ..............................................................................................5-7
4. How to ride ........................................................................................................... 8-9
5.
Safety notes ...................................................................................................... 10-13
6.
Battery instructions ............................................................................................14-15
7.
Parameter .........................................................................................................16
8.
Maintenance......................................................................................................17
9.
Warranty card....................................................................................................... 18
Packing list
1. Product
Electric scooter*1
2. Accessories
Charger*1 Wrench*1 User Manual*1
T25
*If anything missed, please contact the dealer in time!
-01- -02-
Electric Scooter
User Manual
To ensure safe use, please r ead
the instruction manual
carefully.
This instruct ion manual
contains import ant safety matters ,
please read
itcarefully. Do not
use the electric s cooter until you
read the manual careful ly and

Product introduction
Rear wheel brake
Handlebar
LED Display
Front wheel brake
Light &
Function button
Power button
Throttle button
Fault display Multifunction
Speed Gear
Speed unit
Power
Headlight
Pole
Folding clasp
Frame
Front Wheel
Reflector
Kickstand
Hook
Anti-slip pedal
Battery unlock screw
Fender
Tail lights
Plate
Motor
LED display
Instructions of buttons
1. Power Switch: Long press the power button to turn on/off.
2. Function Button:
A: Short press function button: Cycle to switch gears.
Beginner mode: NO gear indicator . Normal
mode: Gear indicator shows white.
Sports mode: Gear indicator shows red.
B: Shortly press the function key twice to turn on/off the headlights, and the
taillights will on or off Synchronously.
3. Accelerator: Press the acceleration button to start and accelerate.
4. Brake: Hold the brake handlebar tobrake.
5. Cruise mode: Keep the current speed(≥6KM/h) for 6 seconds to enter
the cruise mode. Exit the cruise mode when pressing the accelerator
again or the brake.
Note: When the brake is active, pressing the throttle button to
accelerate is invalid!
-03- -04-

Product assembly
1. How to assemble
Assemble
2. How to fold
1. Unfold the pole and fasten the folding
lock.
2. Connect the two cables, which is the
communication wire between displaypcb
and controller pcb. Align the notch and
connect.
Disassemble
3. Align the T-bar of the scooter then insert
it into the pole, use the screw provided
with the scooter to install and fix it.
1.Lift up the fixing bolt of folder. 2.Open the folder wrench.
1. Loosen the screws that secure the
T-bar of the scooter.
-05-
2. Pull out the head of the scooter, unplug
the communication line between the
display and the controller, the dismantling
part of the head of the scooter is complete.
3. Fold the pole.
-06-
4. Gently press down the hook to
the rear baffle.

3. Battery removal and installation.
Remove the battery
How to ride
Install the battery
1. Unscrew the pedal cover
screw counterclockwise.
4.Lift the battery strap and
take out the battery.
2. Lift the pedal cover from
the quick-release screw on
the rear wheel side.
3. Unplug the charging plug
and the power plug of the
controller.
1. Wear helmets and other protective equipment before riding.
2. Long-Press the power button to turn on scooter, stand on the pedal with
one foot, press the accelerator, and push the other foot back on the ground.
1. Put the battery vertically 2.Connect the charging plug 3.Cover the pedal and
into the scooter. and the power plug of the
controller to the battery.
fasten the silicone edge
of the pedal.
-07-
4. Install the screws and
tighten it clockwise.
3. When the electric scooter is sliding,
put the other foot on the pedal and
keep both feet remain stable.
-08-
4. Continuously press the throttle to
speed up. Turn the handle to adjust
the direction.

Safety notes
5. Hold the brake grip firmly to slow down and stop.
Note:
1. Riding in rain or snow, the braking distance will be extended,
Pls pay attention to slow down.
2. The rear brake can be used for normal driving. The front and
rear brakes need to be used together for emergency braking.
Don’t use the front brake for emergency braking at high speed.
Otherwise, it can cause a rollover.
1. Please abide by traffic laws when using electric scooters.
Forbidden to ride it into motor lanes.
P
2. Don’t park electric scooters in the building's lobby,
evacuation corridor, or safety exit.
＞100
kg
6. When the scooter stops or runs at
a slow speed, you can get off.
7. Please don’t ride at high speed before
you are familiar with the performance of
the scooter to avoid accidents.
3. DO NOT ride after drinking
or taking medicine.
4. Forbidden to ride with overweight
(maximum load: 100Kg).
-09- -10-

5. Forbidden to ride on the road with heavy water, which is easy to
cause danger.
9.Forbidden for multiple people or carrying children to ride an
scooter at the same time.
＜16 ＞60
6.Pregnant women and users younger than 16 years old or older than
60 years old are not allowed to ride.
10.Forbidden to modify the battery of an electric scooter privately.
Modification of the battery is dangerous, and improper operation may
cause the battery to explode or fire.
7. Forbidden to ride electric
scooters up and down steps
or jumping obstacles.
-11-
8. Forbidden to leave the handlebar
with one hand or both hands at the
same time when riding.
11. Forbidden to modify electric scooters privately. Private
modification may cause an unstable electronic system and
cause danger when riding.
-12-

Battery instructions
This is about how consumers charge and maintenance , also hereby listed the detailed spec
of battery for your info, please refer to this manual well and follow so as to keep long lifespan ,
performance for the battery.
6.1 Battery parameters
Name Parameter Name Parameter Name Parameter
Type lithium battery Battery Capacity 15.6Ah Rated Voltage 36V
Max Charging
Voltage 42V Max Charging
Current 2A Charging time 8-9h
Temperature -10-40°C Charging
Temperature 0-40°C Store Time
(-10-40°C)
3 months
(full charge)
Recommended tire pressure:
220Kpa~240Kpa
12. Before riding an electric scooter, please carefully check the scooter
condition make sure that there are no signs of looseness or damage on any
part.
Power circuit, front and rear brakes
6.2 Warns for battery
1. The battery must be charged and used within the temperature range required by the
battery specification to make the electric scooter work stably and efficiently.
2. Please make sure you take off the charger when you install the battery to prevent any
danger from happening.
3. It is never allowed to dissolve or impale the battery, also make sure NO metal stuff go
contact with the battery pin electrode, otherwise it might break the battery .
4. It is forbidden to disassemble or pierce the battery pack casing to avoid short circuit
caused by metal objects contacting the battery contacts, otherwise it may cause
battery damage or personal injury.
5. It is potentially causing fire or explosion if water entering battery circuit , thus stop
using the battery in case this happening and go to the after sale immediately.
6. You are only allowed to charge the battery with the original adaptor packed,
otherwise it will be causing any unexpected consequence.
7. If finding the battery broken and smells bad or felt hot , you need to stop using and
keep the battery away from other stuffs.
8. It helps prolong the lifespan if storing battery after 100% fully charged 9.It
is not allowed to store the battery under -20°C or higher 50°C condition.
10. You have to charge it to at least 80% capacity if battery not used more than 30 days.
Better to charge it 100% full every 90 days to protect the battery function.
11. It will help prolong the battery lifespan significantly that you charge well accordingly to
the manuals after every driving instead of running it out. At room temperature,
the batter y can play a higher range and performance. But batter y life and
Front light Rear light Reflector performance will degrade if used at temperatures below 0℃. Typically, the
13.Before using the electric scooter, check whether the power circuit,
front and rear lights, reflectors, front and rear brakes are normal, and stop
using it and repair it in time if there is an abnormality.
-13-
range may be half or less than at room temperature at -10°C.
12. Do not charge and park electric scooters in residential buildings. Keep away from
combustibles when charging, and the charging time should not be too long.
-14-

13. Improper disposal of used batteries may seriously pollute the environment.
Please abide by local regulations when disposing of this battery.
Tips:
1. When the internal temperature of the battery exceeds 50°C, the battery is in
a protected state and cannot be charged.
2. After fully charged, the electric scooter exhausts its stored power after about
90-120 days of standby. If it is not charged in time, it may cause damage to
the battery due to excessive discharge. This damage is unrecoverable and it
is beyond of our warranty.
6.3 Charging steps
1. Open the dust cover on the battery charging stand.
2. Connect the DC plug of the charger to the battery charging socket.
3.Connect the AC plug of the charger to the AC power (100-240V,50/60Hz)
socket, the red light on the charger will light up, start charging, and the
indicator will turn green when the charging is completed.
Tip: When the battery is charged separately, the charging status can be viewed on
the charging indicator on the battery. It displays red color when charging and green
color after full charging.
Changing method 1: Changing method 2:
Charging
indicator light
Parameter
Battery
interface
Note:
Charging port
Only use the original electric scooter charger for charging. Do not use any other
models of power chargers to avoid danger caused by voltage mismatch.
-15- -16-
Product name Electric scooter
Item No. X9
Main specification
Unfolding size: mm*mm*mm 1110*530*1230
Folding size: mm*mm*mm 1110*530*535
Center distance of front and rear wheels mm 825
Net Weight kg 23
Max speed km/h 40
Max load kg 100
Max climbing angle °15
Operating temperature °C -10 ~ +40
Storage temperature °C -20 ~ +45
Waterproof level /IP54
Battery specification
Battery type /Li-ion batter y
Battery capacity Ah 15.6
Rated voltage(DC) V36
Maximum charging voltage(DC) V42
Motor specification
Motor type /Permanent magnet
brushless
Rated power W500
Rated voltage V36
Charger specification
Input voltage(AC) V100~240(50~60Hz)
Output Power W84
Output voltage V42
Output current A
2

Maintenance
8.1 Cleaning and storage of electric scooter.
If there are stains on the surface of the electric scooter, Wipe with a damp soft cloth,
if the plastic parts of the body are scratched, use sandpaper or other abrasive
materials for polishing.
Tips:
1. It is forbidden to use alcohol, gasoline, kerosene or other corrosive and
volatile chemical solvents to clean, otherwise it will seriously damage the
appearance and internal structure of the scooter.
2. It is forbidden to use high-pressure water guns to spray and flush. When
cleaning the electric scooter, make sure the scooter is turned off, and the
charger has been unplugged and the dust cover of the charging port has been
fastened, otherwise, it may cause electric shock or major failure due to the
scooter was flooded.
3. Electric scooter needs to be stored in a cool and dry indoor place. Try to avoid
storing outdoors for a long time. Sun exposure, overheating, and cold outdoor
environments will accelerate the appearance of electric scooter and tire aging,
and reduce the use of the electric scooter and their lithium battery life.
8.2 Maintenance of electric scooter tires.
The tires of this product are pneumatic. When the tire height sinks 20%-30%, it
needs to be inflated. The recommended inflated tire pressure is 220 Kpa-240
Kpa. The tire needs to be inflated at least once in 2-3 months. Regular inspection
of the inflation can reduce the puncture situation and extend the life of the tire.
Warranty card
9.1 The product has passed the inspection of the quality control
department and allowed to be sold.
Please keep the warranty card and purchase invoice properly, and present the
warranty card and purchase invoice when repairing.
Effective date :
Quality inspection pass seal:
9.2. Warranty Card
Username Gender
Age
Mailing address
Phone Zip
Purchase address
Price Sales ordernumber
Description &
Specification
Body number
Dealer signature User signature
Please keep the warranty card and purchase invoice as after-sales proof. This card
must be provided during the warranty. If this card is not provided or the card is altered
privately, the company has the right to do non-warranty treatment!
-17- -18-