CAUTIONS FOR INSTALLATION
When installing the speaker on a wall or ceiling, it
should be secured firmly using rigid anchor bolts to
prevent it from coming off. Also, care should be
taken with regard to the resonance of the mounting
brackets caused by speaker operations.
INSTALLATION SAMPLE
1. Speaker Stand
If you would like to insert a speaker stand please
remove three alan screws (screw size 8mm) which
are in a triangular corner. Then insert the speaker
top holder carefully to avoid scraping.
When using several
speakers at the same time,
special care must be taken to
ensure that the output level of
the speakers would match
each other in order to avoid
feedback which may burn
the tweeter with high
frequency.
2. Mounting the Speaker to the Ceiling
First hold the speaker bracket under the ceiling, then
screw the bracket into the ceiling wall. Unscrew the
two alan screws found on the center of both the
speaker sides. Place a rubber gasket for the sound
quality, and screw the speakers back into the
brackets as shown in the diagram below.
We recommend that you seek professional
installation service for your protection and safety.
3. Mounting the Speaker to the Wall
You must use wooden or concrete screw depending
on the wall’s material around installation area.
Wooden use woodscrew concrete use concrete
screw. Screw size is 8mm for both screws.
2
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK DO NOT REMOVE COVER (OR BACK) NO
USER-SERVICEABLE PARTS INSIDE REFER
SERVICING TO QUALIFIED PERSONNEL
NOTE
NOTE
When installing the
speakers to the
brackets you must
insert a rubber gasket
to protect speaker
sound quality.
Top Holder Included
Speaker Stand is not included
8mm
expanding bolt
8mm screw8mm
screw Rubber
gasket
Rubber
gasket Speaker
Bracket Included
woodscrew
woodscrew
