Big Boys Toys and Hobbies FG Monster Truck 4X4 Kit User manual

Instruction Manual FG Monster Truck 4X4 Kit
Big Boys Toys and Hobbies www.bigboystoysandhobbies.com 866-237-7366

1. Remove all bodywork.
2. Remove Tires & Wheels, Rollbar
etc...
3. Remove Side Plates. These
will be the last thing you put on.
4. Remove Engine and Gas tank.
5. Rear Diff needs to come out.
Everything else you can leave
together.
6. Take the diff apart keeping all
spider gears intact.
7. Remove diff from new kit. It will come
out you dont have to loosen anything.
8. Insert the chainwheel shell in to the
diff. Make sure you put the gear on first
then slide the diff down of the shaft. This
is important b/c you cannot get it back
apart once together. USE LOCK TIGHT!
Big Boys Toys and Hobbies www.bigboystoysandhobbies.com 866-237-7366

9. See how the gear goes on first then the
diff slides in the housing. USE LOCK TIGHT!
10. Ready assembled differential
**See how the gear goes on first.
11. Hang up complete differential in
the chain
12. Assemble rear axle with differential,
across steering wheels screw. At this point the wheels are
barley going to turn. The chain is very tight but dont worry! It
will loosen up after it has been ran 5-10 minutes.
13. Differential screws getting started...
14. Ready rear axle
15. Front shock absorbers disassemble
16. Piston rod with interpiece and
Plastic part with screw protection
mount. The part you need is screwed into the front shock
tower of the new kit. This piece makes the shock set up
higher to accomidate the front drive shafts...
Big Boys Toys and Hobbies www.bigboystoysandhobbies.com 866-237-7366

17. Ready shock absorbers. See the
piece towards the bottom of the shock. This
is important or the truck wont turn.
18. Shock absorbers insert
19. Cotakers mount and with
Screw protection fasten
20. Between and Servoplatte remove
21. Bodywork holder and receiver's box
mount
22. Original disc on new Servo-Saver-
Axis lay
23. Exchange trace pole. I used the one
that was already on the kit.
24. Complete steering system and trace
pole on the inside drilling of the stub
axle mount. See how the ball and socket are
flipped to the other side.
Big Boys Toys and Hobbies www.bigboystoysandhobbies.com 866-237-7366

25. Install servos. You will need a heavy
duty Y connector to connect them.
26. Mount intersheet with bodywork
holder
27. Change out the factory engine
mounts with kit engine mounts
28. Insert engine. Remember that you
are using the new motor mounts
provided by the kit.
29. Distance holders in the rollbar
mount
30. Rollbars and side parts
screw on, tubes fasten
31. Off you go! Your Done!
Big Boys Toys and Hobbies www.bigboystoysandhobbies.com 866-237-7366