Biontech BTS-1000 User manual
USER GUIDE BOOK
Electrolysed Water Sanitiser
Please read this manual before using
this device to ensure safe and correct use
BTS-1000
Be aware of the following before using the electrolysed
water sanitiser.
1. Follow all the instructions in this manual carefully.
2. Keep out of reach of children, infants and animals.
3. DON'T use in confined spaces. Always use in well ventilated areas.
4. DON'T spray directly toward people or animals and don't inhale
the electrolysed water vapour.
5. Sensitive people who have respiratory diseases or allergies need
to be carefull when using this device.
6. DON'T inhale or drink the electrolysed water. If you drink the
electrolysed water consult a doctor immediately.
7. ONLY use electrolysed water with NO accelerator (salt) when using
as a deodoriser, or disinfecting, or for cleaning your hands or feet.
8. You can spray electrolysed water onto baby toys, and to clean
fruits and veggies, but after cleaning and before using, wash
thoroughly with clean water and dry.
9. DON'T spray into people's eyes. If you get some in your eyes,
immediately rinse with clean water and consult a doctor.
10. Wash your hands after using the electrolysed water or wear
protective gloves while using it.
11. For deodorising clothing, bedding, or furniture, use in a well-
ventilated place.
12. DON'T use the device near heaters or open flames.
13. DON'T disconnect the spray bottle while the device is electrolysing
the water. Wait until it is finished its electrolysing cycle.
14. Take care to ensure that the terminal parts of the device are never
in contact with water. If there is any moisture on them, remove
the power plug and immediately gently wipe the terminals dry
before using.
WARNING!
1
01 Introduction
02 Uses
Sanitisation
Deodorisation
Cleaning
Safe sanitised, deodorising and oxidising water generated
by the latest electrolysis technology.
Using common tap water, it can produce strong electrolysed water
(Hypochlorous acid - HOCL) for sanitising, deodorising and cleaning.
Powerful electrolysis method via titanium electrodes.
Smart current control - guarantees current safety overload.
Safe to use on skin (with no accelerator).
Micro droplet sprayer (MDS) with comfortable hand grip.
SAFE
SAFE
SAFE
SAFE
SAFE
SAFE
It has been suggested to remove pesticide residues on the
surface of fruits and vegetables.
Sanitises up to than 99.9% of harmful microorganisms.
Spray electrolysed water onto a surface or a cloth and wipe
over the surface, reducing surface odour.
Easily clean away stains or smudges off surfaces.
Removal pesticide residue
Characteristics of electrolysed water
High concentration of electrolyte sanitisation and deodorisation
water are maintained for about 7 days. After 7 days the
electrolytes are returned to their original state in the water.
Avoid storing in direct sunlight and store it in a cool place.
2
Product description
03
Product name
Electrolysed water sanitiser (Spray BTS-1000, Pitcher BTS-1100)
BTS-1000
Components
1 product set, Spray, AC plug, AC Adaptor, Accelerant, Spoon,
User's guide.
Product
specification
Spray - D 90(mm)x W 90(mm)x H 265(mm)
Base - D 170(mm)x W 170(mm)x H 55(mm)
Product weight
and volume
Sprayer 350g
350ml
Materials
- Hydrogen generating device: Titanium (Iridium plating)
- Main unit: ABS
Manufacturer
BionTech Co., Ltd.
Registration of Broadcasting and Communication Equipments R-R-btp-BTS-1000
Product specification
Spray head
Spray bottle
Electrode parts inside
Base
Operating Buttons Accelerant
Spoon
촉진제
Accelerant
BTS-1000
3
Attach the adaptor's connector
into the bottom of the base
groove as shown in figure 1.
Then sit base on a flat dry surface and
plug in power supply.
Electrolysis
Electrolysis is a process of decomposing water through an electrochemical
redox reaction by applying electricity to the process.
The effect of electrolysed water
- Deodorising effect on food waste, animals smells and toilet odour
- It has been suggested to remove pesticide from fruits and veggies
- Sanitisation effects by reducing bacteria
Electrolysed water
Electrolysed water is water that has gone through
the electrolysis process. It contains hypochlorous
acid (HOCL).
Electrolysed water usage
Sanitisating your home, toilet, school, vehicle, etc.
It can be used for general cleaning purposes.
Component Installation
Explanation of terms
04
05
Product name
Electrolysed water sanitiser (Spray BTS-1000, Pitcher BTS-1100)
BTS-1000
Components
1 product set, Spray, AC plug, AC Adaptor, Accelerant, Spoon,
User's guide.
Product
specification
Spray - D 90(mm)x W 90(mm)x H 265(mm)
Base - D 170(mm)x W 170(mm)x H 55(mm)
Product weight
and volume
Sprayer 350g
350ml
Materials
- Hydrogen generating device: Titanium (Iridium plating)
- Main unit: ABS
Manufacturer
BionTech Co., Ltd.
Registration of Broadcasting and Communication Equipments R-R-btp-BTS-1000
Figure 1
수돗물 전해수전기분해
tap water Electrolyzed
water
Electrolysis
4
06 Using the device
1. Fill up the bottle to the maximum level with tap water.
2. For a stronger solution, add a level teaspoon (0.5g) of accelerant to
the water.
3. Combine with water, stir well before starting the electrolysing process.
1 2
4
3촉진제 0.5g 3
Accelerant 0.5g
1
3
2
The maximum
is 350ml
5
Only use the spoon provided and only use a level spoon each time.
Adding the accelerant will increase the solution concentration of HOCL.
Don't add extra amounts of accelerant.
Electrolyse just once and test solution on the surface.
Higher concentrations of sanitised water can be achieved by
elecetrolysing the water more than once. Don't exceed more than 3
times.
Only use the accelerant we provided.
Don't use other chemical accelerant.
4. The sprayer bottle fits onto the top of the base.
5. Pressing the Power Button (middle button) will activate the base unit.
Two settings, either press the low or high button.
■Low : 1 min run time / generating standard electrolysed water.
■High : 2 min run time / generating strong electrolyzed water.
6. When the electrolysis process is done, the base will beep.
■ Only use tap water (Don't use groundwater,
contaminated water, rain water and purified water).
■ When generating electrolysed water, it is normal to smell a
light disinfectant (chlorine) smell, this is normal.
1 2
4
■ Low Mode
■High Mode
5
Caution when adding accelerant
Accelerant
6
07 Maintenance
The electrolysed water in the device will neutralise after about 3-5 days.
When the device is not in use for a long period of time (weeks), tip out the
water and allow the device to dry. Place in a dry space out of direct sunlight.
Don't store in a fridge as it may degrade the device’s performance and
cause it to stop working.
Wipe the exterior of the device with a dry cloth. Don't use any chemicals
and general cleaning detergents. Be careful not to get water into the
electrical terminals on the base or on the electrical contacts on the
underside of the sprayer bottle. Do not use excessive force on the terminals
or contacts. If there is moisture, remove it completely and let everything
dry out.
This device has a reverse electrolysed electrode cleaning system, so
generally it only needs a scale clean every 6-12 months unless white scale
can be seen on the electrodes.
If water is left in the device for a long period of time, scale will build up on
the electrodes and the device will not work properly. It is recommended to
remove the water if the device isn't going to be used for a week or two.
Periodically check to see if there is any scale build up either on the
electrodes or on the inside of the bottle or jug.
To clean, mix together 200ml of warm tap water and 1.0g of citric acid (stir
until dissolved). Add solution to the bottle/jug and leave for 2 hours. Pour
out and discard the solution. Rand rinse thoroughly with clean tap water,
rinse at least twice.
The white scale material is a mineral build up of calcium and magnesium
from the tap water.
Maintenance
Cleaning the exterior of the device
Cleaning the interior of the device
Cleaning scale
7
Cautions when using the device
1. DON'T use in confined spaces. Always use in well ventilated areas.
2. DON'T inhale or drink the electrolysed water. If you drink the electrolysed
water consult a doctor immediately.
3. DON'T spray into anyone's eyes. If it gets into your eyes, immediately rinse
with clean water and consult a doctor.
4. Wash your hands after using the device or wear gloves while using it.
5. ONLY use electrolysed water with NO accelerator (salt) when using on your
hands or feet as a deodoriser or as a Sanitiser.
6. Keep out of reach of children, infants and animals.
7. DON'T use this device near heaters, open flames, heating devices or
pressure cookers.
8. If you turn the device upside down, then water could leak from the spray
head.
User Instructions
1. Make sure to set up the base on a flat clean dry surface.
2. DON'T move the device during electrolysis as it will damage the device.
3. DON'T repeat the electrolysis process more than three times in a row. There
is a risk of overheating and damaging the device.
4. When the electrolysis is finished. DON'T touch a contact terminals as there is
still power going through them.
5. There is a risk of discoloration or deformation when used on textiles, leather,
porous surfaces and/or some metals.
6. DON'T store the bottle/jug in a refrigerator.
7. When removing the adapter plug from the power outlet, hold the plug body
and pull it out. If you pull it out by the cord, it may cause damage to the cord
and an electric shock. If the adapter is damaged, DO NOT disassemble or try
to repair it. Call us on 1800 268 469 for a replacement.
8. DON'T let water get into the AC adapter or use wet hands to touch the AC
adapter. You may get an electric shock.
9. DON'T put any objects (metal or any other conducting material) into the
bottle or Jug.
10. DON'T disassemble or modify the device in any way.
08 Safety precautions
8
Condition Check Action
LED light off Is the power connected
properly?
Try again after connecting the power
properly. Press the power on button.
LED light on. However
air bubbles have not
occured.
Is the sprayer bottle
properly connected with
the base?
Refer to page 5. Properly combine the
sprayer bottle with the base and then try
again. If it does not work, please contact
customer service.
Air bubbles seem weak. Did you use purified or
bottled water instead of
tap water?
Please use tap water. More air bubbles
are generated when an accelerant is
added than when only tap water is used.
Device doesn't work
when accelerator is
added.
Is the amount of
accelerant correct for
adding?
Only add one level spoon full (0.5g) from
the supplied spoon then operate.
Sprayer doesn't spray. Did you use hard water?
Hard water is water
that has high mineral
content (calcium and
magnesium).
01. If the tap water is hard then scale may
have built up on the electrodes. Also the
spray nozzle may become clogged. If it
does not work, immerse the nozzle into a
diluted solution of a 1:1 ratio of detergent
and water. If it still doesn't work, contact
our customer service on 1800 268 469.
02. Due to the nature of the semi-
automatic spraying nozzle, the spraying
action may not work if the nozzle is filled
with air. If it still does not work after
attempting at least 5 pumps on the
trigger then contact our customer service
on 1800 268 469.
Trouble shooting guide
09
9
This device is covered by a 12-month Manufacturer’s Warranty against defects.
For full details refer to https://www.alkaway.com.au/policies/warranty/
■ Warranty
1. A warranty against defects is a representation communicated to a consumer that if
the goods or services (or part of them) are defective, AlkaWay will:
- repair or replace goods (or part of them) or
- provide a refund as per AlkaWay refund policy to the consumer.
2. Any warranty period starts from the date of purchase. To validate your warranty
please keep a copy of your Proof of Purchase (invoice). You will need it if a warranty
claim is made.
1800 268 469 to receive return instructions including a Return Authority Number
(RA#). We do not accept returns without an RA#.
4. Cost of freight is the purchaser’s responsibility as it is not a part of the device's
purchase price.
5. When the damage to the device is caused by the customer's negligence or a natural
disaster, repairs will be charged even if it is still under warranty. More details below.
■ Out of warranty
T
he following scenarios are subject to a service fee even if the device is still under
warranty.
1. A breakdown caused by inserting foreign objects into the bottle or jug.
2. Damage to the device or malfunction as the result of impact to the device or from
the device being dropped.
3. Damage or warping of the bottle or jug exterior caused by solvents such as cleaning
liquids, thinners and benzene cleaners.
4. Failure caused by plugging the device into an incorrect voltage power supply.
5. Failure as a result of using parts or consumables that are not produced by Biontech.
6. Loss of or damage to parts as the result of customers disassembling the device.
7. Failure as a result of repairs or modifications to the device by an unauthorised
technician.
8. Damage caused by an impacts to the charging terminals to the electrical contacts.
9. Failure as the result of not abiding by the safety cautions stated in this User Guide
(You can use the device safely and for a long time if you abide by these cautions).
10. Failure as the result of natural disasters such as lightning, fire, storm, flood, gas, salt
damages or an earthquake, etc.
11. Other scenarios where failure is caused by customer's negligence or fault.
10 Warranty
10
For all customer and service inquiries,
call us on 1800 268 469
AlkaWay Australia
AlkaWay United States
AlkaWay Canada
AlkaWay UK
AlkaWay EU
AlkaWay Singapore
AlkaWay Support
| www.alkaway.com.au
| www.alkaway.com
| www.alkaway.ca
| www.alkaway.co.uk
| www.alkaway.eu
| www.alkaway.sg
| support.alkaway.com
Copyright AlkaWay 2021
Table of contents
