Bird b gone SOLAR BIRD REPELLER RPLR-SLR1 User manual

BIRDBGONE.COM | 800.392.6915
INSTALLATION QUESTIONS?
Call Bird•B•Gone®at 949.472.3122 or 800.392.6915
Email: [email protected]
Scan to watch our installation instruction videos:
SOLAR BIRD
REPELLER™
INSTALLATION INSTRUCTIONS
RPLR-SLR1
Solar-Powdered Spinning Bird Deterrent
Thank you for purchasing the Bird B Gone® Solar Bird
Repeller™. For best results, please read these instructions
before using the Solar Bird Repeller and retain them for
future reference.
The Solar Bird Repeller is a portable solar-powered bird
deterrent that uses continuous motion to deter large
pest birds from landing and perching. Powered by a
solar panel, two 2.5-foot telescoping "arms" mounted
above the unit spin continuously, protecting up to a
5-foot diameter circle. The spinning movement eectively
deters birds from the area. The Solar Bird Repeller is not
recommended where birds have been nesting.
PACKAGE CONTENTS
II. PRIOR TO INSTALLATIONI. ASSEMBLY
• One Bird Repeller with Solar Panel attached.
• Two Telescoping Wands.
• Two Mylar Streamers for Telescoping Wands (optional -
not necessary for eectiveness of operation).
1. Disinfect and Clean All Surface Areas
Remove all debris including overhanging branches, leaves,
nests, etc. Clean and disinfect area using hospital grade
disinfectant. Allow area to dry before installation. Visit
birdbgone.com/safety for additional information.
2.Charge the repeller in full sun light for a minimum of
8 hours to pre-charge the batteries.
DO NOT USE THE SOLAR BIRD REPELLER
UNTIL IT HAS BEEN FULLY CHARGED
FOR AT LEAST 8 HOURS.
1. Remove package contents.
2.Attach Solar Panel
Locate Solar Panel hinge
attachment, loosen nut and
remove screw. Insert Solar Panel
into housing and secure with
screw and nut.
3.Attach Telescoping Wands
Locate the two screw holes at the
top of the unit. Insert the threaded
end of the Telescoping Wands. Turn
clockwise to tighten and secure.

INSTALLATION INSTRUCTIONSSolar-Powered Spinning Bird Deterrent
SOLAR BIRD REPELLER™
BIRDBGONE.COM | 800.392.6915
INSTALLATION QUESTIONS?
Call Bird•B•Gone®at 949.472.3122 or 800.392.6915
Email: [email protected]
Scan to watch our installation instruction videos:
III. INSTALLATION
IV. MAINTENANCE
Please follow the "BEFORE INSTALLATION" instructions on
the previous page before proceeding with the installation.
1. Solar Panel Placement and Alignment
Placement
For optimal solar charging, position the solar panel
facing South.
Place in an area with direct, uninterrupted sunlight
throughout the entire day.
Solar Panel Alignment
Adjust the Solar Panel by
locating the solar panel hinge,
loosening the screw, selecting
the desired position, and
tightening the screw securely.
1. Cleaning
Regularly clean dust and debris from the Solar Panel to
ensure optimal charging.
2.Replace Batteries
Daily use can gradually diminish battery life. Replace
AA rechargeable batteries when there is a noticeable
decline in spinning speed or operating time. The battery
compartment is located at the bottom of the unit.
4.Turn Unit On
Locate the ON/OFF switch on the back of the unit. After
the batteries have fully charged during the pre-charge
period in the sun, turn the switch to the ON position.
ON/OFF Switch
Battery Compartment
Flexible Mounting Feet
2.Telescoping Wands
Extend Telescoping Wands to the
desired length (up to 2.5’ each).
Optional: Tie Mylar Streamers
to the ends of the Telescoping
Wands.
3.Secure the Solar Bird Repeller
Ensure the flexible mounting feet are secured with
screws and/or other suitable fasteners. For uneven
surfaces, use bungee cords or tie-downs for added
security and ease of removal.
3.Turn O when not in use
When the unit is not in use, turn the ON/OFF switch to the
O position to conserve battery power.
Note: If the batteries deplete during the night, the unit may
take slightly longer to restart in the morning. The solar
panel will gather sucient energy to resume spinning and
recharge the batteries.