Bison Baseline Collegiate 180 Degree Breakaway... User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 180 Degree Breakaway Goal B 1 Cover Plate (Installed)
C 28-32 X 3/16” Round Head (Installed)
Phillips Machine Screw D 2 Nylon Net Tie
E 1 1/4” Long Arm Hex Key F 1 Anti Whip Net
G 2 Release Pressure Adjustment Screws (Installed) H 1 Goal Hardware Bag
Warning!!!
The Vertical Assembly Bolt is under Extreme Spring Pressure! Do Not Adjust or Remove!
♦ Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦ Read all instructions before proceeding.
—— Instruction Manual ——
180 DEGREE BREAKAWAY GOAL
1. Remove the two 8-32 Machine Screws (C) and remove Cover Plate (B). Mount the 180 Degree Goal
(A) to backboard with the hardware provided in the Goal Hardware Bag (H). Make sure the Goal is
level then tighten hardware. See Figure 1.
Date: 10/26/04 Rev: 1 B.A. N.J.C. File: \drive.f\pub\inst\180breakaway Ref#: 910184
Figure 1

2
2. Attach Net (F) to the Goal (A) by starting at position 1, which is the largest opening between the two
shortest net lock tubes. Insert the Nylon Net Tie (D) through the short tube nearest position 2. Hold the
net up to the bottom of the goal and push Nylon Net Tie (D) under the net and into the next net lock
tube. Repeat this procedure at each of the 12 positions. Once the Net (F) is attached at position 13, push
the Nylon Net Tie (D) back into position 1. To insure that the Net (F) is secure, pull the bottom
downward and check for movement in the Nylon Net Tie (D). See Figures 2 and 3.
3. The breakaway release pressure has been factory preset. You can increase this pressure by turning the
Release Pressure Adjustment Screws (G) clockwise using the 1/4” Long Arm Hex Key (E). Make sure
to turn each screw an equal amount otherwise your goal will not function properly. 1/4 of a turn makes
a significant difference in release pressure, it is advised to make subtle adjustments until you reach the
break pressure of your choice. Likewise if you prefer a lower pressure, turn the Release Pressure
Adjustment Screws counter-clockwise following the same guidelines. See Figure 2.
Figure 3
Figure 2