
Assembly Instructions
Accurately mark out bracket holes on wall using spirit level,
to dimensions as shown on Technical Data Sheet.
Drill two 10mm diameter holes to a minimum depth of 65mm
& insert wall plugs (A).
Position brackets (B) with grub screw holes as shown in
figure 1 for maximum rigidity and attach to wall with 7mm
diameter x 60mm screws (C) and washers (D).
Attach lugs (E) to radiator.
Hang radiator on to brackets (B) and tighten grub screws (F).
Push on end caps (G).
Electric radiators should be fitted only by a qualified electrician
and must be earthed and connected to a cable outlet in the
bathroom in accordance with I.E.E. wiring regulations. The
electrical connection should be made to a ‘5 amp fused fixed
spur’ located outside the bathroom.
Note: for maintenance purposes, cable outlets must remain
accessible and cables must not be buried directly into walls.
FITTING INSTRUCTIONS
fig 1. Bracket Positions
A
B
C
D
E
F
Tape measure
Allen key - 8mm
Spanner - 13mm
Screwdriver - small & medium flathead
Electric drill
Masonry drill bit - 10mm diameter
Spirit level
AWall Plug 2
BBracket 2
CScrew - Hex Head, 7mm dia x 60mm 2
ELug 2
FGrub Screw 4
GEnd Cap 2
DWasher 2
Tools & Material Required Key Component Qty
Electric Cobra-Therm Towel Radiator
G
G
Issue 8.0
© Bisque, a division of Zehnder Group UK Ltd