Bissell Cleanview Turbo 1994U User manual

Updated by A. Lentz 10/7/2021P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994U\1994U No or Low Suction.docx
1) Detach hose from base of canister by pushing on release tab and pulling out.
2) Detach hose from extension wand by grasping each piece and pulling them
apart. Do the same to detach the foot.
Low or No Suction
Cleanview Turbo
1994U

Updated by A. Lentz 10/7/2021P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994U\1994U No or Low Suction.docx
3) Remove dirt tank by pressing release button and lifting tank away from machine.
4) With all pieces detached, inspect all dirt flow openings for clogs.
5) Insert broomstick through wand and hose to clear debris.
6) Also, inspect hose section by section for holes or cracks. If a hole or crack is
found,
BISSELL Consumer Care: please refer to product changeover guide.
External Support: Contact BISSELL
7) Reattach pieces by inserting them into their corresponding parts.
8) If still no suction, inspect dirt cup and filters.
9) With dirt tank still removed, over a trash bin, press empty latch on back of tank
to empty debris. Snap shut bottom lid.

Updated by A. Lentz 10/7/2021P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994U\1994U No or Low Suction.docx
10) Separate top handle from bottom tank by grasping carry handle and base of dirt
tank. Twist the carry handle counterclockwise.
11) Grasp filter handle and lift it out of dirt tank.
12) To separate filter pieces, twist filter handle counterclockwise while grasping
base of outer cyclone.
13) Next, twist filter handle counterclockwise while grasping base of inner cyclone.
Clear away any debris build up. Wash pieces if necessary.
NOTE: DO NOT wash filter. To clean, tap on side of trash bin.
14)To reassemble, align tabs on filter piece with their mating slots on the inner
cyclone and twist clockwise.

Updated by A. Lentz 10/7/2021P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994U\1994U No or Low Suction.docx
15) Do the same to connect inner and outer cyclone pieces. Reinsert pieces into
dirt tank. Filter should sit level.
NOTE: filter will not sit level if tabs on front are not aligned
16)Reattach top lid to dirt tank by aligning clear notch with slot on top lid. Clear
notch should point towards unlocked. Twist clockwise to lock.

Updated by A. Lentz 10/7/2021P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994U\1994U No or Low Suction.docx
17) Reattach dirt tank to canister and turn on.
If the machine still has no or low suction,
BISSELL Consumer Care: please refer to product changeover guide.
External Support: Contact BISSELL