Bissell CROSSWAVE 1785 SERIES User manual

Quick Start Usage Instructions
WARNING
Refer to the enclosed user guide for complete
instructions and important safety notices.
CROSSWAVE™
QUICK START GUIDE 1785 SERIES
160-9479 04/16 RevB
1. First, insert the
handle at the top
of the body of the
machine until you
hear a click.
click
HARD FLOOR
BUTTON
RUG
BUTTON
LARGE AREA CLEANING
SMALL AREA CLEANING
2. For small area cleaning (<350 sq ft),
fill the clean water tank with warm tap
water to the first water fill line. Then add
formula to the first formula fill line.
For large area cleaning (up to 700 sq ft),
fill the clean water tank with warm tap
water to the second water fill line. Then
add formula until you get to the second
formula fill line. Screw the cap back onto
the clean water tank.
3. On the back of the
machine, align clean
water tank with the
grooves and slide
tank into place until
you hear a click.
4. Turn machine on by
selecting the type
of floor you will
be cleaning. For
hard floors, choose
the HARD FLOOR
button and for area
rugs push the RUG
button.
5. Each time you use
the product, hold the
solution trigger for 10
seconds to prime the
system with cleaning
solution before you
begin cleaning. When
you pull the trigger, LED
lights will illuminate.
When solution is
flowing, you will see
bubbles forming at the
edges of the brush roll
window.
You are ready to start
cleaning with your
BISSELL® CrossWave!™

Tips &Tricks
›› On hard floors, there is no need to
vacuum before using CrossWave™.
This machine vacuums and washes
at the same time.
›› For overly challenging and stuck-
on messes on hard floors, activate
the RUG mode and hold your
CrossWave™over the mess. Using
short passes while holding the
trigger allows the multi-surface
brush to go to work.
Getting the Best Clean from Your CrossWave™
For everyday Cleaning:
HARD FLOORS & RUGS
QUICK START GUIDE For further instructions
reference the User Guide or visit
www.BISSELL.com
Dirty Machine?
EASY CLEAN UP
For best results, rinse the dirty water tank, brush roll and brush
chamber after each use. After allowing your machine and
components to dry completely, reassemble your product, making
sure the machine’s brush window is securely in place before cleaning.
Choose the setting that matches the floor type you
will be cleaning. Prime the system first by holding the
solution spray trigger for 10 seconds. When you’re
ready to clean, hold the trigger on both the forward
and backward pass for great cleaning results.
HARD FLOOR
RUG
CLEAN UP REASSEMBLE
›› To dry floors faster, release the
trigger and run the machine over the
floor without dispensing solution.
›› When cleaning area rugs, remove any
excessive mud from your area rug
prior to using your CrossWave™.
10 Seconds
DRY
›› When cleaning excessively dirty or
muddy hard floors, or if the brush
roll looks dirty, use the Easy Clean
Storage Tray to rinse the brush roll
before cleaning your area rugs.