Bissell CROSSWAVE X7 CORDLESS PET PRO User manual

CROSSWAVE® X7
CORDLESS PET PRO
BATTERY REMOVAL
INSTRUCTIONS
3011, 3276, 3277, 3279 SERIES
WARNING This product
contains Lithium-Ion rechargeable batteries.
DO NOT mix Lithium-Ion batteries with
general household waste. According to
Federal and State regulations, removal
and proper disposal of Lithium-Ion batteries is required.
For specific battery disposal instructions please contact
Call2Recycle at 877-723-1297 or visit www.call2recycle.org.
NOTICE Disconnecting the battery will destroy the
appliance and invalidate the warranty.

1. Remove the Clean Water Tank
and the Dirty Water Tank.
2. On the back of the machine, press
the button under where the handle
fits into the machine, while pulling
the handle up.
3. Remove the product face
with a screwdriver by sliding a
screwdriver between the face and
the body of the product.
4. Remove two screws under the front
face of the machine body. Remove 11
screws that attach the front cover to
the body of the product.
5. Use a screwdriver to remove
the 3 screws holding the battery in
place. Remove the battery pack.
6. The front cover and the body of
the product are attached by three
connectors.
7. Unplug the yellow connector
from the body of the product.
8. Unplug the orange connector
from the body of the product.
9. Unplug the red and black wired
connector.
10. Remove the battery pack from
the product.
11. After the connectors are
disconnected from the body of the
product.
12. Use electrical tape to tape the
end of the connectors and recycle
the battery.
Disposing of the Battery
Before disposing the battery, make sure:
• The machine is disconnected from the docking station.
• The clean and dirty water tanks are empty or removed from the machine.
Needed for Disassembly:
• Phillips-head Screwdriver
• Electrical tape
©2022 BISSELL Inc. All rights reserved. Part Number 1627863 11/21 RevB