Bissell CROSSWAVE 1785 SERIES User manual

Quick Start Usage Instructions
WARNING
Refer to the enclosed user guide for complete
instructions and important safety notices.
CROSSWAVE™
QUICK START GUIDE 1785, 1713 SERIES
160-8628 Rev 12/15
1. First, insert the handle at
the top of the body of the
machine until you hear a
click.
2. For small area cleaning
(<300 sq ft), fill the clean
water tank with hand
hot tap water to the
first water fill line. Then
add formula to the first
formula fill line.
For large area cleaning
(up to 600 sq ft), fill the
clean water tank with
hand hot tap water to
the second water fill line.
Then add formula until
you get to the second
formula fill line. Screw the
cap back onto the clean
water tank.
3. On the back of the
machine, align clean water
tank with the grooves and
slide tank into place until
you hear a click.
4. Turn machine on by
selecting the type of floor
you will be cleaning. For
hard floors, choose the
HARD FLOOR button and
for area rugs choose the
RUG button.
5. Each time you use
the product, hold the
solution trigger for 10
seconds to prime the
system with cleaning
solution before you begin
cleaning. When you pull
the trigger, LED lights will
illuminate.
When solution is flowing,
you will see bubbles
forming at the edges of
the brush roll window.
click
2ND WATER
FILL LINE
2ND FORMULA
FILL LINE
HARD FLOOR
BUTTON
RUG
BUTTON

Tips &Tricks
›› On hard floors, there is no need to
vacuum before using CrossWave™.
This machine vacuums and washes at
the same time.
›› For overly challenging and stuck-
on messes on hard floors, activate
the RUG mode and hold your
CrossWave™over the mess. Using
short passes while holding the
trigger allows the multi-surface
brush to go to work.
Getting the Best Clean from Your CrossWave™
For everyday Cleaning:
HARD FLOORS & RUGS
QUICK START GUIDE For further instructions
reference the User Guide or visit
www.BISSELL.com
Dirty Machine?
EASY CLEAN UP
Make sure to rinse the dirty water tank, brush roll and brush chamber
after each use. Also be sure your machine’s brush window is in place
before you start cleaning. For best results rinse the dirty water tank,
brush roll and brush chamber after each use. Before you clean again,
make sure the machine’s brush window is securely in place.
›› If your CrossWave™leaves foam
behind, it may be time to flush the
system. Fill the clean water tank
tank with water to the formula line
for Small Area cleaning. Using RUG
mode, recline and hold the trigger
until the water tank is depleted.
Choose the setting that matches the type of floor
you will be cleaning. Prime the system by holding the
solution spray trigger for 10 seconds before cleaning.
When you’re ready to clean, hold the trigger on both
the forward and backward pass for best results.
HARD FLOOR
RUG
CLEAN UP REASSEMBLE
›› To dry floors faster, release trigger and
run the machine over the floor without
dispensing solution.
›› When cleaning area rugs, remove any
excessive mud from your area rug
prior to using your CrossWave™.
10 Seconds
DRY
›› When cleaning excessively dirty or
muddy hard floors, rinse the brush
roll with clean water before cleaning
an area rug.