Bissell CROSSWAVE Guide

CrossWave® Cordless Max using the 3-
in-1 Docking Station & Clean out Cycle |
Support
The 3-in-1 Docking Station functions as a clean out tray, charging station, and storage
tray for machine, brush rolls, and filter.
•Before placing machine on 3-in-1 Docking Station make sure Brush Roll Drying
Tray is installed correctly, once it is securely installed it will click and sit flush on
the floor
Clean out Cycle:
•Place machine on docking station
•Make sure docking station is plugged in
•Fill clean water tank with warm tap water to the clean out cycle icon on the tank
oPut clean water tank back on machine

•Press clean out cycle button and let machine go through full 40 second cycle
oIf machine stops in middle of cycle and orange dirt tank indicator starts blinking
on digital display, remove and empty dirty water tank
▪Clean out cycle button will be inactive until dirty water tank is emptied
▪Place empty dirty water tank back on machine and the clean out cycle will
resume
oIf machine does not start the clean out cycle when the button is pushed, re-seat
the machine onto the dock and allow it to charge for 10 minutes before trying
again
•Repeat as needed
•When cycle is completed, remove brush roll window by grasping front and pulling
upward

•Pull tab on brush up to remove brush roll
oPlace brush roll in drying tray to air dry

•Take machine off docking station
oWipe off any excess water on docking station

•Return machine to docking station
•Empty and clean both tanks before storing machine
Charging:
•Plug adaptor into wall outlet
•With machine on docking station, battery LED lights will illuminate white while
charging
•If lights are not on, remove machine and realign on docking station
•If one light is blinking white battery is at less than 10%
•For a full charge allow machine to charge for 4 hours
o3 white lights indicate a fully charged battery