Bissell CROSSWAVE Installation instructions

My CrossWave® Cordless Max shuts off
automatically | Support
My CrossWave® Cordless Max shuts off automatically | Support
•Machine will automatically shut off if dirty water tank is full, look to see if orange dirty water
tank icon is illuminated, and empty dirty water tank
oIf machine is shutting off with orange dirty water tank icon is illuminated, but dirty water tank
is not full, follow the steps in Cleaning Your Dirty Water Tank
•Turn machine on by pressing power button
•If machine does not turn on, refer to No Power troubleshooting
•Remove handle by using a screwdriver or other blunt object to press round release button
found above clean tank on back of machine
oPull up on handle to remove
oReinsert handle into machine until it clicks

•Recline machine to activate brush roll
oIf brush roll does not turn, or machine shuts off after a short time, turn machine off by
pressing the Power button
•Remove brush roll window by grabbing pull tab and pulling upward
•Hold brush roll tab and pull upward to remove brush

•Check ends of brush roll for wrapped debris or hair

•Check plastic gear end on foot of machine and remove hair or debris wrapped in this area
oTurn gear by hand to test spin
▪If gear doesn't spin, or spins too loosely, visit a BISSELL Authorized Service Center or
Contact Us
•Hold colored pull tab on brush roll and spin other end
oIf brush doesn't spin, a replacement should be ordered
•Reinstall brush roll by inserting gray tipped end into right side of machine and then pressing
down on colored tab until it clicks into place

•Reattach brush roll window
oLine up tabs on front edges of foot and then push window into place until it clicks

•Turn machine on, recline, and test to see if CrossWave turns on and will run
oIf not, please contact us