Bissell ProHeat 2X Revolution Pet User manual

My ProHeat 2X® Revolution®Pet Carpet
Cleaner has no suction to the hose | Support
•Machine must be in upright position for suction at the hose
•If dirty tank is full, it must be emptied
•Check both tanks for cracks or other damage
oIf part is damaged, it will need to be replaced
•Check the bottom of the water tank to make sure it has a red auto-load gasket attached
•Tanks must be seated properly
oTo return the dirty tank, angle the tank and insert bottom-first
oTilt the tank toward the machine and push the top in until it clicks into place
•The clean water tank will not click, but should sit flush with no gaps

•Dirty tank plug needs to be pushed in securely
oSuction will be reduced if there are gaps
•Reinsert the hose
•Be sure the colored hose release clip is facing out, away from machine

•Check hose for cracks or damage
oHose will need to be replaced if damaged
•Check hose for clogs
oRemove hose and run clean water through one end, hold other end over sink - water should flow
through
•Check red filter screen under dirty tank for debris
•Check for suction at the motor duct gasket next to the red filter
oRemove collection tank and turn the machine on
oPlace hand over the gasket opening to check for suction
oIf no suction, contact us