Bissell Total Floors® Complete Vacuum 52C2 User manual

YOUR TOTAL FLOORS®VACUUM
COMES WITH THE FOLLOWING COMPONENTS:
®
A) VACUUM BASE B) UPPER HANDLE C) CARRY HANDLE D) FEBREZE®FILTER
E) FOAM FILTER F) TOOL STORAGE CLIP G) HOSE GUIDE CLIP H) HOSE GUIDE/
TOOL CADDY
I)TURBOBRUSH
(select models)
J) PET TURBOERASER
(select models)
K) LONG REACH
DUSTING TOOL
(select models)
L) PET HAIR FABRIC TOOL
(select models)
M) DUSTING BRUSH/
UPHOLSTERY TOOL
N) EXTENSION WAND O) EDGE CLEAN/
CREVICE TOOL
P) TWIST N’ SNAP HOSE
52C2, 61C5 SERIES
QUICK START GUIDE
WARNING:Refer to the enclosed user’s
guide for complete instructions and important safety notices.

1.
2.
1.
2.
3.
©2012 BISSELL Homecare, Inc
Grand Rapids, Michigan
All rights reserved.
Printed in Vietnam
Part Number 110-4564
Rev 5/12
Visit our website at:
www.bissell.com
For information about repairs or replacement parts,
or questions about your warranty, call:
BISSELL Consumer Care
1-800-237-7691
Or visit the BISSELL website: www.bissell.com
Filter Assembly
Your Total Floors®vacuum comes with a
preinstalled Foam Filter (E). Before assembling
and using your vacuum, ensure that the Foam
Filter or Febreze®Filter (D) is installed. See page
5 of your user’s guide for more information.
Handle Assembly
1. Slide the Upper Handle (B) onto the back
of the Vacuum Base (A).
2. Locate the screw packet taped to the Carry
Handle (C). Guide the Carry Handle into
place onto the back of the Upper Handle
and insert two of the screws into the
existing holes. Tighten screws securely
with a Phillips screwdriver.
Tools and Hose Assembly
1. Attach the Tool Storage Clip (F) to the back of
the handle by snapping the piece into the unit
as shown. Push piece straight in—with the tool
grips facing down—until it snaps into place.
2. Attach the Hose Guide Clip (G) to the
left side of the back of the Vacuum Base.
Insert tab at a 45 degree angle and turn
clockwise so it snaps into place.
3. Attach the Hose Guide/Tool Caddy to the
bottom of the vacuum base. Align the
component with the appropriate grooves
on the back of the unit. Slide into place
and insert screw into the existing hole.
Tighten securely with a Phillips screwdriver.
4. Place the TurboBrush Tool (I) or Pet
TurboEraser Tool (J) into its holder from the
front of the vacuum (above the Suction Power
Indicator). Secure the Tool by snapping the
tool into the Tool Storage Clip (F).
5. Mount the Extension Wand (N) and Pet Hair
Fabric Tool (L) or Long Reach Dusting Tool (K)
to the back of the unit as shown on page 4 of
your user’s guide.
6. Line up the tabs of the Twist n’ Snap Hose
(P) with the corresponding notches and turn
clockwise. Slide the end of the hose into
the Hose Wand Base and wrap around the
Hose Guides as shown on page 4 of your
user’s guide.
Scan the code to
view a short
assembly video.
Or locate the
video in the Video
and Image Gallery
on www.Bissell.com/total-floors-pet