Bkav QCS605 User manual

P a g e 1 | 8
USER MANUAL AI BOX
USER MANUAL QCS605 AI BOX

P a g e 2 | 8
USER MANUAL AI BOX
Dimensions

P a g e 3 | 8
USER MANUAL AI BOX
Physical Description
1. Outer View
Reset
DC 12V
LAN
USB
Type-C
PWR/STATUS/LAN LEDs
MODE BUTTON
DI/DO
terminal
HDMI
Wifi
Wifi
GPS
MIC
Audio
SD
Card

P a g e 4 | 8
USER MANUAL AI BOX
2. Mode Button
Mode button is used in this device is tactile switches type, user-developed operating
script.
3. Reset Button
The reset button is used to factory reset the device.
Reset procedure: Unplug the Box B01 -> Hold down the reset button -> Plug in the
power -> Continue to hold for about 10 seconds and then release it -> Box will perform a
factory reset and boot up at the Google Setup Wizad screen
4. USB Type C
One port USB Type C 3.1 is available in this device for debug and flashing images.
5. HDMI
One port HDMI 1.4 Type A is available in this device for transmitting images, videos
to external devices such as monitors.
6. Alarm I/O (DI/DO terminal)
Various I/O supports including Alarm-in, Alarm-out (Relay).
DI1+
1st Alarm input signal line terminal, positive
DI1-
1st Alarm input signal line terminal, negative (GND)
DI2+
2nd Alarm input signal line terminal, positive
DI2-
2nd Alarm input signal line terminal, negative (GND)
DOA
1st Alarm output signal line terminal 1
DOB
1st Alarm output signal line terminal 2
DOC
2nd Alarm output signal line terminal 1
DOD
2nd Alarm output signal line terminal 2
Two alarm outputs with NO contacts of IM06GR (TE) relay:
Switching power: 60W/62.5VA
Switching voltage: 220VDC/250VAC
Switching current: 2A
Two alarm inputs can support input voltage level are 5VDC to 12VDC.

P a g e 5 | 8
USER MANUAL AI BOX
7. LEDs
System Power Green LED
Power is ON/OFF
Status RG LED
User-developed operating script.
LAN RG LED
User-developed operating script.
8. SD Card
QCS605 supports Micro SD Card up to 2TB.
9. Hardware Installation.
1. Install the dual Wifi Antenna.

P a g e 6 | 8
USER MANUAL AI BOX
2. Install the GPS Antenna.
3. Install Mic, Audio, USB Type-C, Micro HDMI
GPS Antenna
Mic
Audio
USB Type-C
HDMI

P a g e 7 | 8
USER MANUAL AI BOX
4. Install SD Card.
5. Install DI/DO
a. Install Terminal connector.
SD
Card

P a g e 8 | 8
USER MANUAL AI BOX
b. Installing Cable DI/DO to block terminal. Then, to use Screwdriver fix
the cable.