Blackjet UX-1 User manual

UX-1
Specications are subject to change without further notice.
All trademarks, trade names and copyrights are properties of their respective owners.
Thunderbolt and the Thunderbolt logo are trademarks of Intel Corporation in the U.S. and/or
other countries.
Reader Module Service Guide

Removing Top Cover
**Please Power off UX-1 and remove Power Cable
from UX-1. Use ESD Glove to protect sensitive
electronics during assembly.**
1. Locate the Top Cover Screw of the UX-1.
Page 01
Top Cover Screw

Removing Top Cover
Page 02
2. Use a Phillips Screwdriver and loosen
and remove the top cover screw.

Removing Top Cover
3. Push and Lift top cover from housing.
Page 03

Removing Reader Module
4. Locate Reader Module that you will be
servicing or swapping.
5. Locate the 2 x Screws from reader
module.
Page 04
Reader Module Screws

Removing Reader Module
6. Loosen and remove the 2 x Screws from
reader module with Phillips Screwdriver.
Page 05

Removing Reader Module
7. Locate the Reader Module connector.
8. Push the connector and the Reader
Module will disconnect from main board.
Page 06
Reader Module Connector
Push Reader Module Connector

Removing Reader Module
9. Locate the ejected Reader Module and
remove from the UX-1.
Page 07

Installing Reader Module
1. Locate the new Reader Module and
insert into the UX-1.
Page 08

Installing Reader Module
2. Install and tighten the 2 x Screws with
Phillips Screwdriver to secure reader module.
Page 09

Install Top Cover
1. Place Top Cover back onto UX-1 housing.
Page 10

Securing Top Cover
Page 11
1. Use a Phillips Screwdriver and Tighten
the screw to secure the top cover.

Hardware Setup
Page 12
1. Your UX-1 is now ready to be setup.
For more details please refer to the UX-1
User’s Guide.
Atech Flash Technology, Inc.