Blaupunkt H4 User manual

Enjoy it.
Operating and Installation Instructions
12V VEHICLE LIGHTING
5000K & 6000K
LED HEADLAMP
H4 H7 H8/H11/H16
HB4 HIR2

Safety Notes
This product has been manufactured according to
established safety guidelines. However, dangers may still
occur if the safety notes in this manual is not observed.
This manual is intended to familiarize the user with
the product’s important functions. Read this carefully,
prior to install the product. Keep this manual in an
easily accessible location. In addition, do observe the
instructions of the devices used in conjunction with
the product.
General Safety
•
•
•
•
•
•
•
•
•
This manual may be updated from time to time without
any notice.
CAUTIONS
Disclaimer
In no event shall Blaupunkt be liable for any direct,
indirect, punitive, incidental, special consequential
damages to property or life and whatsoever arising out
of or connected with the use or misuse of our products.
USA & CANADA: This product is not intended for sale in
the United States and Canada. If purchased in the U.S. or
Canada, this product is purchased on as-is basis. No
warranty, whether expressed or implied is provided in
the U.S. or Canada.
1
Headlamp is intended for installation and operation
in a vehicle with 12V vehicle system voltage and can
be used in headlights with H4 halogen lamps.
Ensure headlamp does not have defects before
installation.
Keep the headlamp away from children.
Keep the headlamp away from ammable areas
or liquids.
The headlamp should be stored in dry and low
humidity place.
Avoid skin contact with the high temperature/
working headlamp when replacing headlamp. Allow
headlamp to drop to room temperature before
replacing the headlight.
Do not modify product, or expose product to dust,
grease stains, or scratch the surface of the headlamp.
Do not look directly at the operating headlamp, it
may cause eye damage.
After installation, ensure below are working correctly
1. Correct light/beam pattern
2. Indicators are working
3. Wiring are connected correctly
4. Covers are installed back to the car correctly

Applicable to : Reector headlight
Product Name : 134250W (5000K), 134260W (6000K)
Technology : LED
Power : 26W±10%, 26W±10%
Operating Voltage : 13.2V
Luminous Flux : 2100lm ±20%, 1900lm ±20%
Water Resistant Rating : IP65
Lifespan : 3000 hour
Colour Temperature : 5000K & 6000K
Base : P43t
Applicable to : Projector, reector & fog headlight
Product Name : 197250W (5000K), 197260W (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 13.2V
Luminous Flux : 2300lm ±20%
Water Resistant Rating : IP65
Lifespan : 3000 hour
Colour Temperature : 5000K & 6000K
Base : PX26D
Applicable to : Projector, reector & fog headlight
Product Name : 136650W (5000K), 136660W (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 13.2V
Luminous Flux : 2300lm ±20%
Water Resistant Rating : IP65
Lifespan : 3000 hour
Colour Temperature : 5000K & 6000K
Base : PGJ19-1/2/3/5
STRUCTURE & FUNCTIONS
2
H4
H7
H8/H11/H16

3
SPECIFICATIONS
Applicable to : Projector, reector & fog headlight
Product Name : 100650W (5000K), 100660W (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 13.2V
Luminous Flux : 2300lm ±20%
Water Resistant Rating : IP65
Lifespan : 3000 hour
Colour Temperature : 5000K & 6000K
Base : P22D
Applicable to : Projector & reector headlight
Product Name : 101250W (5000K), 101260W (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 13.2V
Luminous Flux : 2300lm ±20%
Water Resistant Rating : IP65
Lifespan : 3000 hour
Colour Temperature : 5000K & 6000K
Base : PX22D
HB4
HIR2
If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt
authorized dealer if problem persist.
TROUBLESHOOTING
Problems
One of the headlamp
doesn’t work
Both headlamps doesn’t
work
Dim Headlight
Causes
The headlamp has burned-out.
Fuse has blown.
Incorrect wiring connections.
No power to the circuit, bad
ground or failed switch.
Broken alternator or power
supply problem.
Weak car battery.
Solutions
Replace with a new headlamp.
Replace with a new fuse.
Examine if positive and negative power connectors
are connected correctly.
Examine if wiring for power, ground or switch are
connected correctly.
Examine if power supply voltage is correct.
Recharge the weak car battery or replace with a
new car battery.

Open the hood of the vehicle.
Find the installed location of the original
halogen bulb.
Remove the halogen bulb from headlight
housing.
Install the headlamp into headlight
housing and turn clockwise to secure it.
Connect the headlamp cable to vehicle
wiring hardness.
1.
2.
3.
1.
2.
PRE-INSTALLATION INSTALLATION INSTRUCTION
4
Warning cancellar adaptor may be needed in
case warning signal light up after installation.
Remove bulb, turn it 180° & reinstall in case bulb
does not light up.
Fit for 12V vehicle only.
•
•
•

Designed and engineered by Blaupunkt Competence Centre
134260W H4 6000K
1 581 19 014 35 01
197260W H7 6000K
1 581 19 015 35 01
136660W H8/H11/H16 6000K
1 581 19 016 35 01
100660W HB4 6000K
1 581 19 017 35 01
101260W HIR2 6000K
1 581 19 018 35 01
134250W H4 5000K
1 581 19 019 35 01
197250W H7 5000K
1 581 19 020 35 01
136650WH8/H11/H16 5000K
1 581 19 021 35 01
100650W HB4 5000K
1 581 19 022 35 01
101250W HIR2 5000K
1 581 19 023 35 01