Blaupunkt 5DA36258AU User manual

Instructions for installation and use
&RRNHU+RRG
'$$8
5DA39258AU

2
2
INDEX
SAFETY INFORMATION......................................................................................................................................................... 3
CHARACTERISTICS ............................................................................................................................................................. 6
INSTALLATION...................................................................................................................................................................... 7
USE ........................................................................................................................................................................................ 9
CARE AND CLEANING ....................................................................................................................................................... 10
$8

$8 
SAFETY INFORMATION
For your safety and correct operation of the appliance, read this manual
carefully before installation and use. Always keep these instructions
with the appliance even if you move or sell it. Users must fully know the
operation and safety features of the appliance.
The wire connection has to be done by specialized technician.
x The manufacturer will not be held liable for any damages resulting from
incorrect or improper installation.
x The minimum safety distance between the cooker top and the extractor
hood is 650 mm (some models can be installed at a lower height,
please refer to the paragraphs on working dimensions and installation).
x If the instructions for installation for the gas hob specify a greater
distance, this must be respected.
x Check that the mains voltage corresponds to that indicated on the
rating plate fixed to the inside of the hood.
x Means for disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
x For Class I appliances, check that the domestic power supply
guarantees adequate earthing.
x Connect the extractor to the exhaust flue through a pipe of minimum
diameter 120 mm. The route of the flue must be as short as possible.
x Regulations concerning the discharge of air have to be fulfilled.
x Do not connect the extractor hood to exhaust ducts carrying
combustion fumes (boilers, fireplaces, etc.).

$8 
x If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a sufficient degree of aeration must be
guaranteed in the room in order to prevent the backflow of exhaust gas.
When the cooker hood is used in conjunction with appliances supplied
with energy other than electric, the negative pressure in the room must
not exceed 0,04 mbar to prevent fumes being drawn back into the room
by the cooker hood.
x The air must not be discharged into a flue that is used for exhausting
fumes from appliances burning gas or other fuels.
x If the supply cord is damaged, it must be replaced from the manufac-
turer or its service agent.
x Connect the plug to a socket complying with current regulations, lo-
cated in an accessible place.
x With regards to the technical and safety measures to be adopted for
fume discharging it is important to closely follow the regulations pro-
vided by the local authorities.
WARNING: Before installing the Hood, remove the protective films.
x Use only screws and small parts in support of the hood.
WARNING: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
x Do not look directly at the light through optical devices (binoculars,
magnifying glasses…).
x Do not flambè under the range hood; risk of fire.
x This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and under-
stand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
x Children should be supervised to ensure that they do not play with the
appliance.

$8 
x The appliance is not to be used by persons (including children) with re-
duced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction.
Accessible parts may become hot when used with cooking appliances.
x Clean and/or replace the Filters after the specified time period (Fire
hazard). See paragraph Care and Cleaning.
x There shall be adequate ventilation of the room when the range hood is
used at the same time as appliances burning gas or other fuels (not
applicable to appliances that only discharge the air back into the room).
x The symbolon the product or on its packaging indicates that this
product may not be treated as household waste. Instead it shall be
handed over to the applicable collection point for the recycling of elec-
trical and electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed informa-
tion about recycling of this product, please contact your local city office,
your household waste disposal service or the shop where you pur-
chased the product.

$8 
CHARACTERISTICS
Components
Ref. Q.ty Product Components
11 Hood Body, complete with: Controls, Light, Blower, Fil-
ters
81 Directional Air Outlet grille
20 1 Closing element
Ref. Q.ty Installation Components
12a 4 Screws 4,2 x 44,4
12b 2 Screws 4,2 x 12
12e 2 Screws 2,9 x 9,5
Q.ty Documentation
1 Instruction Manual
12b

$8 
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
The hood support surface must be 135 mm above the bot-
tom surface of the wall units.
Drill the support with a ø 4,5 mm drill bit, using the drill-
ing template provided.
Cut a hole ø 125 mm in size on the support surface, using
the drilling template provided.
Fix using the 4 screws 12a (4,2 x 44,4) provided.
12a
135
125125
SNAP-ON FITTING
The hood can be installed either directly on the bottom sur-
face of the wall units using snap-on side supports.
Cut a fitted opening in the bottom surface of the wall unit,
as shown.
Insert the hood until the side supports snap into place.
Lock in position by tightening the screws Vf from under-
neath the hood.
CLOSING ELEMENT
The space between the edge of the hood and the rear wall
can be closed by applying the element 20 provided, using
the screws 12b.
20
12b

$8 
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø120
mm, the choice of which is left to the installer.
Fix the pipe in position using sufficient pipe clamps
(not supplied).
Remove any activated charcoal filters.
ø 120
RECIRCULATION VERSION AIR OUTLET
Cut a hole ø 125 mm in any shelf that may be posi-
tioned over the hood.
Connect the flange to the outlet on the shelf over the
hood using a flexible or rigid pipe ø120 mm.
Fix the pipe in position using sufficient pipe clamps
(not supplied).
Fix the directional grille 8 on the recirculation air
outlet using the 2 screws 12e (2,9 x 9,5) provided.
Ensure that the activated charcoal filters have been
inserted.
12e
8
9
125125
ELECTRICAL CONNECTION
Connect the hood to the mains through a two-pole switch having a contact gap of at least 3
mm.
When opening the sliding carriage for the first time after installing the hood, pull it out
briskly until it clicks.

$8 
USE
Control panel
L
M - V
0
1
0
1
2
3
L Light Switches the lighting system on and off.
M Motor Switches the extractor motor on and off.
V Speed Sets the operating speed of the extractor:
1. Low speed, used for a continuous and silent air change in the presence
of light cooking vapour.
2. Medium speed, suitable for most operating conditions given the opti-
mum treated air flow/noise level ratio.
3. Maximum speed, used for eliminating the highest cooking vapour
emission, including long periods.

$8 
CARE AND CLEANING
Grease filters
CLEANING METAL CASSETTE GREASE FILTERS
The filters must be cleaned every 2 months, or more frequently
in case of particularly heavy use of the hood. Filters can be
washed in a dishwasher.
Pull out the sliding suction panel.
Remove the filters one by one, after having disconnected the
relative fastening elements.
Wash the filters, taking care not to bend them. Let them get dry
before refitting them. (The colour of the filter surface may
change throughout the time but this has no influence to the fil-
ter efficiency).
When refitting the filters, make sure that the handle is visible
on the outside.
Close the sliding suction panel.
Charcoal filter (Recycling version)
REPLACING CHARCOAL FILTERS
Warning: Turn the lights off and wait until the lamps cool down
before you change the odour filter.
These filters are not washable and cannot be regenerated, and
must be replaced approximately every four months or more
frequently by particularly heavy use.
Pull out the sliding suction panel.
Remove the grease filters.
Remove the saturated carbon filter by releasing the fixing
hooks
Fit the new filter by hooking it into its seating.
Replace the grease filters.
Close the sliding suction panel.