Page 4
Safety Tips
⚫Position on a flat, stable surface.
⚫A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove
any components or service panels on this product.
Consult Local and National Standards to comply with
The following:
·Health and Safety at Work Legislation
·BS EN Codes of Practice
·Fire Precautions
·IEE Wiring Regulations
·Building Regulations
⚫DO NOT use jet/pressure washers to clean the appliance.
⚫DO NOT use the appliance outside.
⚫DO NOT use this appliance to store medical supplies.
⚫DO NOT use electrical appliances inside the appliance.
(e.g. heaters, ice-cream makers etc.)
⚫DO NOT stand or support yourself on the base,
drawers or doors.
⚫DO NOT allow oil or fat to come into contact with the
plastic components or door seal. Clean immediately if
contact occurs.
⚫Bottles that contain a high percentage of alcohol must
be sealed and placed vertically in the refrigerator.
⚫Always carry, store and handle the appliance in a
vertical position and move by holding the base of the
appliance.
⚫Always switch off and disconnect the power supply to
the unit before cleaning.
⚫Keep all packing away from children. Dispose of the
packaging in accordance with the regulations of local
authorities.
⚫If the power cord is damaged, it must be replaced by
an agent or a recommended qualified technician in
order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this
manual. Correct maintenance and operation of this
machine will provide the best possible performance from
your product.
Pack Contents
The following is included：
·Refrigerator or Freezer
·Shelf guides (2 per door)
·Shelves (1 per door)
·Instruction manual
We pride ourselves on quality and service, ensuring that
at the time of packing the contents are supplied fully
functional and free of damage. Should you find any
damage as a result of transit, please contact your dealer
immediately.
Installation
Note: If the unit has not been stored or move in an
upright position, let it stand upright for approximately
12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging. Make
sure, that all protective plastic film and coatings
are thoroughly removed from all surfaces.
2. Maintain a distance of 20cm (7 inches) between
the unit and walls or other objects for ventilation
increase this distance if the obstacle is a heat source.
3. Ensure the ambient temperature is within the design
range of the cabinet, avoid locations below 15 degrees C.
Beware of enclosed rooms with other refrigeration
equipment as additional ventilation may be required.
Note: Before using the appliance for the first time,
clean the shelves and interior with soapy water, thoroughly dry
afterwards.
3. Set the brakes on the castors to keep the appliance
in position OR level the appliance by adjusting the screw feet.
Fitting the Shelves
1. Place one set of shelf guides on either side of the cabinet
at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
Note: This is vital for ensuring correct drainage of condensation.
Operation
Storing Food
To get the best result from your appliance, follow these
instructions:
·Only store foodstuffs in the appliance when it has reached the
correct operating temperature.
·Do not place hot food or liquid inside the appliance.
·All food must becovered including sauces.
·Do not overload each shelf allow sufficient space to allow for air
movement around the products.
·Do not obstruct the fans inside the appliance.
·Avoid opening the doors for prolonged periods of time.
Turn on
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to [O] and turn on at the socket.
3. Switch on the power [l]. The current temperature within the
the appliance is displayed.
Adjusting the Set Temperature
1. Press and hold the set button for 3 seconds till the C led starts
blinking with the current set temperature shown
2. Use the arrow keys to adjust to the required set temperature
setting.
3. Press the set key to store, then leave for approx. 5 secs till the
display shows the cabinet temperature, the cabinet will then
cool down to the new set temperature.
NOTE! The temperature shown on the display will fluctuate during
normal use as the unit regulates the cabinet temperature.
Manual Defrost
The appliance will automatically run a defrost cycle every six hours.
Note: The cycle starts from the time the appliance is initially
powered up.
To manually defrost the appliance:
1. Press and hold the DEFROST button for 5 seconds.
2. The defrost cycle will start immediately and the Defrost
LEDilluminates. The defrost will last a maximum of 30 minutes
Note: Starting a manual defrost also resets the automatic defrost
timer.
3. The next automatic defrost will start six hours after the manual
defrost has finished.
