bloomming Facet Operating manual
MAINTENANCE GUIDE
CLEANINGINSPECTION
CONTACT
Bloomming Facet, like all materials, should
be cleaned periodically. A regular, seasonal
cleaning program will help prevent
noticeable dirt buildup.
Remove dust from Facet by normal dusting.
You can remove dirt from Facet with a soft
cloth or sponge and a solution of mild soap
or liquid detergent in water.
Always use a soft, damp cloth to blot dry.
Rubbing with a dry cloth can scratch the
material and create a static charge. Never
use scrapers or squeegees. Also avoid
scouring compounds, gasoline, benzene,
acetone, carbon tetrachloride, certain
deicing liquids, lacquer thinner or other
strong solvents.
DO NOT:
• Use strong solvents, highly alkaline or
abrasive cleaning agents.
• Clean in hot sun or at elevated
temperatures.
• Rub with a dry cloth.
If a cleaning material is found to be
incompatible in a short-term test, it will
usually be found to be incompatible in
the eld. The converse, however, is not
always true. Favorable performance is no
guarantee that actual end-use conditions
have been duplicated. Therefore, these
results should be used as a guide only and
it is recommended that the user test the
products under actual end-use conditions.
Inspect your divider from time to time.
Make sure that all facets are closed
correctly. If a facet isn’t closed over the
whole side (all 12 lock points), please close
the facet, otherwise the frame will not be
secured and may fall apart.
If a facet doesn’t close properly, this is
occurred because a frame connector that
isn’t completely pressed into its tube.
To resolve this, open the facet, put the
connector fully back in its tube and close
the facet again with all 12 lock-points. Now
the connector is secured.
Every facet has
12 lockpoints For information or questions visit
bloomming.com
!
NB: If the connector still keeps sliding out of its
tube, remove the facet, take a pincer and give
the aluminum tube (with the connector fully in)
a little squeeze, this will prevent the connector
from sliding out of the tube again. Now you can
place the facet back.
