BLOTZ B06-MW-101 User manual

6mm 3x3 Residential Foyer
B06-MW-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B06-MW-101)
Remove the two “C” shaped sections and the
four shop fronts from the sprue.
Glue the shop fronts to the “C” sections as shown
(etched detail facing outwards) using the lugs on the
top edge of the shop fronts. The lugs on the ends of
the shop fronts will slot together. Leave to allow glue
to dry.
Now remove the four outer sections from the
sprue. Note two of these pieces have 4 lug-holes
in them and two only have two-lug-holes in
them.
Once the inner section has dried turn it over and glue
the outer sections onto it as shown ensuring the outer
sections with the 4 lug-holes are glued to the 4 lugs on
the “C” sections.
Repeat for the other two outer sections.
Finally glue the decorative strips just above the
columns so they cover the lug-holes. Note – two
strips are the same length as the walls and two
overlap slightly to give a continuous band.

6mm 3x3 Residential Middle
B06-MW-151
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B06-MW-151)
Remove the four walls and two bracers from the
sprue. Glue the bracers to the non-etched side
of two identical walls (checking the end lugs to
be sure they are the same) as shown in the
example above. Leave to dry.
Once the bracers are dry apply a little glue to the side
lugs and glue the other walls in place as shown above.
You should now have a hollow square structure.
Leave it to dry.
Finally glue the decorative strips just above the
bottom windows so they cover the lug-holes.
Note – two strips are the same length as the
walls and two overlap slightly to give a
continuous band.

6mm 3x3 Residential Roof
B06-MW-201
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section (B06-MW-201)
Remove the four walls and roof from the sprue.
Apply glue to the edges of the roof and attach
the walls to it using the lugs provided (etched
detail outwards).
Now remove the four rectangles from the sprue.
Each of these has a line etched across it. Apply glue to
one side of the line only and attach it (as shown in the
example above) to the centre ottom edge of each
wall.
Finally glue the decorative strips at the top of
each wall so they cover the lug-holes. Note –
two strips are the same length as the walls and
two overlap slightly to give a continuous band.