BLOTZ B28-VSF-010 User manual

28mm VSF Deck Gun
B28-VSF-010
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the three pieces shown above from the
sprue.
Attach them together as shown.
Take the three “C” shapes and semi circle from
the sprue.
Insert one “C” behind the crossbar, the semi-circle
on the crossbar and the other two “C” shapes in
front as shown above.
Next take the three medium size circles.
And slide them into position (see pic)
Then take the remaining circles…
..and glue them into place.
Finally add the end of the barrel.
The gun mount is made from the pieces shown.

Glue the side to the base, then attach the
“mushroom” shape piece as shown above.
Place the lug of the gun assembly into the side
piece, then attch the other side piece.
Glue the two roundels into position (one on each
side) to ensure the gun sits centrally. Attach the
rectangular block to the top of the gun.
Attach the gun sight / range finder.
The axle is made from these two pieces.
Glue them together as shown.
Attach them to the base of the gun.
Take these base pieces.
Glue the small corner pieces in the ends of the
large section with their longest side taking the
vertical position.
Add the the upper part of the base.
Add the gun with gluing it to allow it to traverse.

The finished model.