BLOTZ B28-ME-004 User manual

28mm Middle Eastern Building #4
B28-ME-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the side and internal walls from the
sprue.
Glue them together to form an “H” shape as shown
above.
Glue this to the base.
Take the front and rear walls…
..and glue them into position.
Take the four sections of steps and wall….
Glue the steps into place as shown above.
Then glue the wall into position.

Take the roof supports as shown above.
Glue them into place so that they extend through the
wall (see pic).
Glue the door into position.
Take the main roof and door section.
Glue them together as shown.
Add the end support.
Then place this onto the lower half of the building.
Take the other three walls.
And glue them into position.
Note: Do NOT glue them to the lower half of the
building if you wish to be able to remove the main
roof section.
Take the remaining roof supports and door.

Glue the supports into place then add the door.
Place (do not glue) the upper roof into position, then
glue the trapdoor to it.
There is a second trap door in case you wish to have
one on the main roof.
The completed building.