BLOTZ B10-CS-103 User manual

10mm / 15mm Cinema
B10-CS-103 / B15-CS-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
These instructions are for both the 10mm and 15mm versions of this building. The images used are of
the 10mm version.
Remove the sections for the right hand side of
the building from the sprues.
Starting with the bottom centre piece glue the walls
to the underside of the roof (as shown above). Note
the wall with the hole in it is at the front.
Take the balustrade pieces from the sprue as
shown above. Note two of these (#2 and #3)
have different size lugs at the ends. The smaller
end will sit into the side wall of the building.
Attach the balustrade starting with piece #1 then
fitting #2 and #3 in place. Then attach the side wall as
shown.
Remove the pieces shown above from the sprue
(NB: The 15mm version has 2 of the one shown
on the right).
Using the lug which extends out from the side wall to
help position them glue the uprights to the side wall
as shown ensuring they all align correctly.

The left side of the building is formed from the
pieces shown above.
Starting with piece #1 glue the walls to the underside
of the roof.
Take the balustrade pieces from the sprue as
shown above. Note one of these ( #3) has
different size lugs at the ends. The smaller end
will sit into the side wall of the building.
Attach the balustrade starting with piece #1 then
fitting #2 and #3 in place. Then attach the side wall as
shown. Note the side wall does not attach to the front
of this section (piece #2).
The central section of the building is formed from
the three pieces shown above.
Glue them together as shown. Note the slice out of
the roof is uppermost in this picture.
Glue the left side of the building to the centre as
shown.
Then attach the right hand side….
…and glue the whole structure to the base. Remove these two pieces from the sprue.

Glue them together as shown. Then fit them to the front of the building.
If desired glue the “Cinema” piece to the front of
the building.
The finished building.