BLUEGAZ BG 64 User manual

HEATER BLUEGAZ
BG 64
WITH ELECTRICAL HEATER AND FAN
ARTIKEL NR 780064
1

2
USER MANUAL
content:
A. Good to know before using.
B. Safety
C. Installation and Operation
D. Install gas regulator and gas bottle
E. Start the gas heat
F. Turn off the gas stove and gas cylinder
G. Use of the fan and electric heat
H. Errors & Actions
I. Remove the gas regulator and replace the gas cylinder
J. Maintenance and Cleaning
K. Storage
L. Warranty
A. GOOD TO KNOW BEFORE USE
This stove requires a minimum of space and ventilation to be used in a safe manner (see
Section C). Ensure that adequate ventilation is always available. Gas stove may only be
used in well ventilated areas. Always leave a window or door ajar (± 2.5 cm). Gas stove must
be installed as described and need an approved hose and regulator (see section C)
Gas type: I3B / P (30) Fuel: Propane Nominal pressure: 28 -30 mbar Max power -
consumption: 4.2 kW - 300 g / t
Piezo ignition with power - consumption: 2.7 kW - 200 g /
t Space for gas cylinder of 11 kg max. My power - consumption: 1.4 kW - 100 g / t
Safety: Oxygen Depletion System (ODS)
Voltage: 220-240V - 50Hz Max.elektrisk thermal power
:2000-2200W Overheat protection: Thermostat Min. electric heating power: 1000W
Fan: 20W
Gas type: I3B / P (30) Fuel: Propane Nominal pressure: 28 -30 mbar Max power -
consumption: 4.2 kW - 300 g / t
Piezo ignition with power - consumption: 2.7 kW - 200 g /
t Space for gas cylinder of 11 kg max. My power - consumption: 1.4 kW - 100 g / t
Safety: Oxygen Depletion System (ODS)
Voltage: 220-240V - 50Hz Max.elektrisk thermal power
:2000-2200W Overheat protection: Thermostat Min. electric heating power: 1000W
The fuel is liquid gas (LPG) that does not pollute. The unit is CE approved and conforms to
the Rules EN 449:2002 standard and applicable "Gas Appliance Directive" (GAD)
90/396/EEC as last modified by "Directive 93/68/EEC".

3
B. SAFETY
• THERMAL PROTECTION ELECTRICAL Ignition flame heats an element that is (if it warms
up) themselves gasolkaminens faucet open. (NOTE NOT gas bottle valve). If the pilot turns
off the gas supply from the equipment crane automatically within a minute.
• ATMOSFÄRSANALYSATOR. This gas stove is equipped with an atmospheric analyzer that
automatically turns off the unit if there is a high percentage of carbon dioxide (CO2) in the
room. If this should occur, ventilate the room well before gas lighting.
• Piezoelectric IGNITION. This is undoubtedly the safest ignition method as it avoids the use
of a free low as manually approximated set.
C. INSTALLATION AND USE
• Always use an approved regulator and hose. Ask the dealer or call us.
• Place the unit on a flat surface.
• Do not use in bedrooms, bathrooms or homes as permanent or permanent heating.
• Do not use in rooms of less than 84 cubic meters of max mode, 56m ³ on medium mode
and 28 m³ of my position.
• Propane stove may only be used in dry clean areas and may not be used in caravans or
similar
• Do not place the appliance near a heat source, keep a minimum distance of one meter.
• Do not place in a location where there is already a gas bottle (even if the latter is used to
another device).
• Use only in rooms with good ventilation and not in areas with flammable gases or flames.
• The appliance must not be used without supervision.
• Do not cover the heater with towels, clothing, etc., or wet laundry to be dried.
• Do not move the heater while it is operating or still hot.
• Do not place the heater near armchairs, curtains or anything that can catch fire.
• In the event of a gas smell, immediately turn off the gas cylinder valve. Do not light bulbs or
flames. Open doors and windows to change the air. Make sure the switch on the gas bottle
valve is securely fastened and that the seal is intact. Have the stove.
• Space for gas cylinder is designed for gas cylinder of maximum 11 kg.
• Ensure that legal and approved LPG is used and the gas cylinder is not exposed to heat or
extreme heat or cold. Always store propane tank in a cool, dry and dark place.
• Check hose and regulator regularly. In case of damage replace immediately otherwise we
recommend that hose and regulator are replaced every two years.
• The appliance must not be used below the surface or below ground level.
D. INSTALLING gas regulator and gas bottle
First Screw the hose at the stove connection valve and tighten the hose clamp. On the other
side of the hose to the regulator clamped with a hose clamp. See instructions for
gasregulatorset.
2nd Make sure the plastic seal (red screw) on the gas bottle valve is intact and unscrew.
3rd Attach the regulator to the gas bottle valve by turning thereto intended key
counterclockwise. Pull tight to seal properly.

4th Place the cylinder in addition the space. Check that the crane can easily be moved and
that the flexible hose is not twisted or pinched.
5th Attach the back cover on the gas stove.
6th Open the tap counterclockwise. Make sure there are no gas leaks and that all
connections are securely closed. NEVER use free flames for this action, but use soap
solution or leak detector.
E. START GAS HEATING
First Follow "INSTALLATION AND USE" and place the gas stove in the desired location.
2nd Open the valve on the gas bottle by turning it counterclockwise.
3rd Push the knob down and hold it fully depressed. Press the piezo button repeatedly until
the pilot and part of the burner lights.
4th Keep the knob pressed for additional 20 to 30 seconds (the time required to heat up
flamdetektorn which keeps the stove faucet open).
5th To adjust the temperature, press the knob slightly and turn it to the desired position,
position 1, 2 or 3
6th At first ignition may be coming out a little smoke, which then does not take place at the
following ignitions.
4
7th Do not move the gas fire when it is hot.
FIRE AND GAS BOTTLE
• Set the gas fire turned into the starting position by rotating clockwise to position 1.
• Note that the valve on the gas cylinder must also be closed completely by turning it
clockwise until the tap is fully closed. The pilot flame goes out.
G. USE OF FAN AND ELECTRIC HEATING
First Plug the cord into an elutag and turn on the fan that runs constantly when it is
on. The heater may only be used with 220-240V.
2nd When the fan is on, you can turn on the electric heat in two stages.
3rd Position I is rated at 1000W and the mode II also turned on, the effect is 2200W.
4th Suspension is done by first turning off both power switches for heat to zero and
then turn off the fan.
Electric fan switch for electric heating

H. ERRORS & MEASURES
Error Causes / Solutions
Torch will not light up - Poor gas inlet
- the controller will not work
The burner has misfires or goes out - Check if there is gas in the bottle
- Check the hose connection
- Consult the dealer or customer service
Unstable flames - Check if there is gas in the bottle
- Replace the bottle.
- Consult the dealer or customer service
The flame does not light - Check if there is gas in the bottle
- Blocked pilot flame
- Consult the dealer or customer service
If the fan does not work, check the fuse (glass fuse 10A) as follows:
The electric fan has a fuse that can be replaced. Make sure the gas stove is off and cool, and the
power cord is unplugged. Inside the gasolkaminens upper left corner is a black fuse holder is opened
by screwing clockwise. Check the fuse and replace if necessary. Screw the fuse holder and plug in the
power cord and check. If the fan is not working now so please
contact your dealer or Scandy Garden.
I. REMOVE gas regulator and REPLACING gas cylinder
• Close the valve and cylinder. Never replace the gas bottle near an open flame or other ignition
sources.
• Remove the cover on the space for gas bottle, remove the cylinder without damaging the flexible
hose. Unscrew the regulator clockwise. Make sure the controller connections are not damaged. Set
the cylinder aside in a safe place.
J. MAINTENANCE AND CLEANING
• Do not clean the stove when in use or when it is hot.
• Use a dry, soft cloth.
• Check the rubber hose periodically and replace if necessary. (Mount not excessively long or short
tubes, 50 cm is sufficient and appropriate length).
• Any repairs must be performed by authorized personnel using original spare parts.
K. INSTRUCTIONS FOR STORAGE
• When the season is over, you should set aside the stove in a dry place and cover it to prevent the
dust off and the burner.
5

L. WARRANTY
The warranty is valid for two years in the following form:
• The warranty starts from the date of delivery, the purchase certificate invoice, delivery note or cash
receipt. During the warranty period changed all original defective parts replaced without charge for
materials and labor costs. Examination of warranty accrues only manufacturer.
• This warranty does not apply to regulator, hose, locking ring and the parts with defects caused by
improper operation, maintenance or storage. The user is in any event for any transportation costs.
CARING FOR THE ENVIRONMENT!
• Your appliance contains valuable materials which can be reused or recycled.
• Leave it to a recycling center when it is consumed.
If you require technical support, please contact:
Box 9188
200 39 Malmö
SVERIGE
Tel 040 – 21 40 00
Email : [email protected]
6