Bluewater APALA Assembly instructions

INSTRUCTIONS FOR THE ASSEMBLY OF THE
APALA 3-WAY PULL-OUT KITCHEN FILTER TAP
1) PLEASE NOTE
Before installing the tap, make sure that the pipes
are connected correctly supplying hot & cold water.
If you are in front of the faucet, the hot water out-
let should be on the le side and the cold water
outlet on the right side.
Make sure the water supply system is equipped
with strainers to ensure that no dirt, such as sand,
rust, limescale or other has entered the tap head.
Make sure there is a 35mm hole in the worktop or
sink.
[email protected] tel - 01403 701988

Insert the O-ring into the ring of the tap body. Insert the faucet body with the gasket into the
opening in the countertop or sink.
From the boom, put a rubber and metal washer on the thread of the tap and screw on the clamp
nut. Screw the body connecon hoses onto the water supply valves.
Open the isolaon valves. Connect the hose from the filters to the hose to the tap using push-fit
coupling (third supply hose).
[e-mail] tel - 01403 701988
PAGE 2

Screw the hose weight to the second hose as shown in the image above. Aer connecng all the hoses, open the
water to test, making sure the connecon are ght.
Before using the tap for the first me, unscrew the pull-out spout and rinse the tap. Aer flushing, screw the
spout p back into place.
Maintenance
The customer is obliged to regularly unscrew and clean the aerator (mixing nozzle) of scale, rust and other foreign
bodies. If the aerator is heavily soiled, replace it with new.
Water working pressure: up to 6 bar —use a pressure reducer for higher pressure.
Water temperature: 4 degrees C—90 degrees C ) opmum working temperature up to 65 degrees C).
PLEASE NOTE— These instrucons are for informaon only and the tap must be installed by a qualified person.
[email protected] tel - 01403 701988
PAGE 3