BoarBuster Color HD User manual

BoarBuster
Color HD Installation Instructions
1. Remove and unfold Tripod Tower then fully extend all legs and lock in place. The Tripod
Tower should be located approximately 15’ to 20’ from the edge of the trap, and the
Winch Stand must be the closest spot on the trap to the Tripod Tower.
2. Slide Small Solar Power Bracket on to Tripod Tower with the bolt holes facing down at a
45-degree angle on the Tripod Tower.
3. Slide Camera Bracket on to Tripod Tower and use provided pin to lock in place.
4. Mount Camera Antenna to the top of the Tripod Tower, then tighten with provided “U”
bolt with a small wrench. Make sure to not overtighten “U” bolt.
5. Use (3) three of the provided Stakes to secure Tripod Tower in place to the ground
6. Attach Solar Panel to the S olar Power Bracket on the Tripod Tower using the provided
bolts making sure the bolt heads are on the panel side of the frame. Ideally the solar
panel should be facing as much to the south as possible to allow it to absorb as much
sunshine as possible.
7. Place the Large Solar Panel Bracket at the bottom of the Solar Panel for maximum
support. Secure the Large Solar Panel Bracket using supplied bolts and wing nuts. Then
use (2) of the provided Stakes to secure to the ground.
8. Mount Camera Plate to the back of the camera making sure that the welded portion is
facing toward the top of the Camera. PLEASE DO NOT OVER TIGHTEN.

9. Mount Camera,with Camera Plate installed, to the Camera Bracket that is installed on
Tripod Tower.
10. Connect Camera Antenna Cable to Antenna after you have removed the protective
cover. Please only hand tighten, making sure it is not overtightened.
11. Place Controller Box under Solar Panel making sure the notched hole is closest to the
panel cable. Insert the Long Latch Cable and Charge Cables thru the notched hole in the
side of Controller Box.
12. Connect color coded cables together inside of the Controller Box by matching the colors
and making sure there is a proper fit. Then, connec t the Red Battery Cableto the positive
(+) terminal on the battery and the Black Battery Cable to the negative (-) terminal on
the battery.
13. Turn the unit on by pressing the red button with a picture of a light bulb, then on the
side of the Camera you will see the Power, Signal, and Carrier lights come on. The lights
are green and typically will illuminate green within 60-90 seconds.
14. Uncoil the Latch Cable and plug into the Latch on the Trap Winch Stand, then use the
Cable Holder to get the cable off the ground and suspended.
15. Log in to BoarBuster HD Portal to review camera angle and position prior to leaving the
field. If adjustment is needed, remove screws on both sides of camera lens with the
supplied driver to adjust camera. You will not be able to adjust the camera lens remotely.

Large Solar Bracket Small Solar Bracket Camera Plate
Camera Bracket Camera Antenna Stakes
Solar Panel Controller Box Camera
Trap W inch Stand Tripod Tower