Boca Systems Lemur-X UPG User manual

1065 South Rogers Circle • Boca Raton, FL 33487 • Phone [phone] • Fax [phone]
Roll Holder Adaptor Kit for Lemur-X UPG (P/N 424184)
Kit will include floor plate (2pcs), one roll holder arm, one spindle, one adjustable stopper and installation hardware.
1. Attach the spindle onto the roll holder arm using the two Philip ¼” Hex head screws.
2. Align the two floor plate pieces (larger piece on top of smaller piece) so that the two screw holes align. See step
# 8 photo to orientate pieces.
3. Install the two 3/16”hex head Taptite screw and tighten.
4. Install the two #4 Kep nuts onto screws and tighten
4X
Rubber Feet
6X
3/16”Hex Head
#4 Taptite
2X
1/4" Hex Head
#8 Taptite
2X
#4 Kep Nut

5. Affix rubber feet onto roll holder plate. See step # 8 photo to orientate feet.
6. You will need to relocate the back two feet. As shown in the photo below.
7. Install the floor plate onto the bottom of the Lemur-X UPG printer. Align the two holes on the floor plate up with
the two mounting holes on the printer. Install the two 3/16”hex head Taptite screws and tighten.
8. Flip both the Lemur -X and attached floor plate so all rubber feet are facing down.
9. Align the two holes on the roll holder up with the two mounting holes on the floor plate. Install the two 3/16” hex
head Taptite screws and tighten.
14.75” length
Do not cover mounting holes
10.50” height

10. Tear off a full turn of the paper or media from the new roll. Caution: It is important that the outer end of the media
is free of glue or other adhesive substance that may cause a paper jam or damage the print head.
11. Place the roll onto the spindle so the media turns in a clockwise direction.
12. Install the adjustable stopper disc onto the spindle and slide into place. The stopper should not be binding
against the roll to prevent it from moving freely.
The Ticket Load Procedure section of the user manual (see link below) reviews how to load media into the printer.
https://www.bocasystems.com/documents/lemur_X_UPG.pdf
Rev 02.19.21
REMOVE
10.50” high