
PRACTICING:
The simulator is designed to meet the needs for ground fighting training, the joints
simulates the real joints of a human body, allowing real training in combat and
promoting a higher pressure, as if you were training with a partner. The manikin
responds your blows with realism and security. However, the simulator joints
have limited resistances, so do not use more pressure than needed for training.
Remember that you’re training with a “partner”.
The head of the simulator cannot be twisted, the product is designed to absorb
only blows and no other action.
Ideal is to use the simulator on a level surface, with a rubber or plastic mat.
CLEANING:
You can use the following products to clean your BOOMBOXE®:
-
Neutral detergent for small stains, applied with a sponge or soft cloth.
-
For tougher stains, use the cleaning solution provided by themanufacturer.
-
Do not use any other product on the skin, as this may damage it.
CLOTHING:
The simulator clothing is made by elastane, so please be careful when wash and
use a quality cleaning product to extend the clothing lifetime.
ASSEMBLY:
The simulator is practically asembled, you’ll only need to fit the legs as shown on
the images below:
If the leg draw system loosens, follow the instructions below:
Important: Follow the sequence and position showed on the images below,
otherwise it will be very difficult to assemble.
1)
Thread the cord through the leg hole, fit the leg to the hip, pull the cord until it
fits into the bar.
2)
The rubber used for the leg draw must be in the parallel position of the leg and
free to move. To adjust it, just turn the hip eyebolt.
2.1)
On the back of the thigh, there is also a cord for the same fitting procedure
to the bar.
3)
Put on the pants and adjust using the cord in the torso to the hip.