Bosch Plena LBB1938/20 User manual

Communications Systems | LBB 1938/20 Plena Power Amplifier
LBB 1938/20 Plena Power Amplifier
www.boschsecurity.com
u480 W power amplifier in a 3U high 19”housing
uEN 54‑16 certified and EN 60849 compliant
u70 V / 100 V and 8 ohm outputs
uDual inputs with priority switching
u100 V input for slave operation on 100 V speaker
line
The LBB 1938/20 is a powerful 480 W power amplifier
in a 3U high 19”case for rack mounting or tabletop
use. LEDs on the front panel show the status of the
amplifier: power, audio output level, and supervised
functions. This high-performance unit fulfills a wide
range of public address requirements at a surprisingly
low cost.
Functions
Dependability
The amplifier is protected against overload and short
circuits. A temperature-controlled fan ensures high
reliability at high output levels and low acoustic noise
at lower output levels. An overheat protection circuit
switches off the power stage and activates an LED on
the front panel, if the internal temperature reaches a
critical limit due to poor ventilation or overload.
The unit operates both on mains power and on a 24 V
battery power supply for emergency back up, with
automatic switchover.
For emergency and evacuation use, the following
functions are monitored: mains presence, battery
present, pilot tone presence, amplifier operation.
Front panel LEDs indicate the status of supervised
functions. The LEDs of pilot tone supervision and
battery status can be switched off for general public
address use. Failsafe (normally energized) relays are
provided for each supervised function. These relays
are always active regardless of the switches on the
rear panel.
Input
The system has two balanced inputs with priority
control, each with a loop-through facility. This makes it
easy to connect remote systems that require priority
control. An additional 100 V line input is provided to
connect the amplifier to a 100 V loudspeaker line, to
provide more power to remote locations.
Gain or level control is located on the rear of the unit
to avoid accidental setting change. A meter with LED-
bar shows the output level.
Output
The amplifier has 70 V and 100 V outputs for constant
voltage loudspeaker systems and a low impedance
output for 8 ohm loudspeaker loads.
The LBB 1938/20 has two separate priority controlled
100 V outputs for zones that only need
announcements made via the priority input, and for
zones that will not get any announcements made via
the priority input.

Controls and indicators
Front
• Meter (LED's for -20, -6, 0 dB and Power ON)
• Battery operation indicator
• Overheat indicator
• Air inlet for forced air cooling
Back
• Level control input 1
• Level control input 2
• Power button
• Mains switch
Interconnections
Back
• Priority line input 1 (XLR/balanced)
• Line loop-through 1 (XLR/balanced)
• Program line input 2 (XLR/balanced)
• Line loop-through 2 (XLR/balanced)
• Priority controlled loudspeaker output terminals
• 24 VDC power supply terminal
• Three loudspeaker direct output terminals
• Two 100 V slave input terminals
• Input 2 enable control terminal
• Input 1 priority control terminal
• Earth connection screw
• Mains socket
Certifications and approvals
Safety acc. to EN 60065
Immunity acc. to EN 50130‑4
Emission acc. to EN 55103‑1
Emergency acc. to EN 54‑16 / EN 60849
Region Certification
Europe CE
CPD
Poland CNBOP
Parts included
Quantity Component
1LBB 1938/20 Plena Power Amplifier
1 Power cord
1 Set of 19" mounting brackets
1 Installation and User Instructions
Technical specifications
Electrical
Mains power supply
Voltage 230 VAC, ±10%, 50/60 Hz
Inrush current 19 A
Max power consumption 2200 VA
Battery power supply
Voltage 24 VDC +15% / -15%
Current max 30 A
Performance
Output power (rms/maximum) 480 W / 720 W
Power reduction on backup
power
-1 dB
Frequency response 50 Hz to 20 kHz (+1/‑3 dB @ ‑10 dB
ref. rated output)
Distortion <1% @ rated output power, 1 kHz
S/N (flat at max volume) >90 dB
Line inputs 2 x
Connector 3-pin XLR, balanced
Sensitivity 1 V
Impedance 20 kohm
CMRR >25 dB (50 Hz to 20 kHz)
Gain 40 dB
100 V input
Connector Screw, unbalanced
Sensitivity 100 V
Impedance 330 kohm
Line loop-through output 2 x
Connector 3-pin XLR
Nominal level 1 V
Impedance Direct connection to line input
Loudspeaker outputs 3 x
Connector Screw, floating
Direct output 100 V, 70 V, 8 ohm
Priority only (from input 1) 100V or 70 V internally selectable
Music (non-priority) only 100V or 70 V internally selectable
Power consumption
Mains operation
Max power 990 W
-3dB 715 W
-6dB 510 W
Pilot tone* 110 W
Idle 25 W
24 VDC operation
Max power 32 A (770 W)
2 | LBB 1938/20 Plena Power Amplifier

-3 dB 26 A (625 W)
-6 dB 18 A (430 W)
Pilot tone* 3.8 A (91 W)
Idle 0.7 A (17 W)
* 20 kHz -20dB with maximum loudspeaker load
Mechanical
Dimensions (H x W x D) 145 x 430 x 370 mm
(19" wide, 3U high, with feet)
Weight Approx. 25 kg
Mounting Standalone, 19”rack
Color Charcoal
Environmental
Operating temperature -10 ºC to +55 ºC (14 ºF to +131 ºF)
Storage temperature -40 ºC to +70 ºC (-40 ºF to
+158 ºF)
Relative humidity <95%
Acoustic noise level of fan <48 dB SPL @ 1 m (max output)
Ordering information
LBB 1938/20 Plena Power Amplifier
480 W power amplifier in a 3U high 19”case for rack
mounting or tabletop use.
Order number LBB1938/20
3 | LBB 1938/20 Plena Power Amplifier
Represented by:
Americas: Europe, Middle East, Africa: Asia-Pacific: China: America Latina:
Bosch Security Systems, Inc.
12000 Portland Avenue South
Burnsville MN 55337, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
Bosch Security Systems B.V.
P.O. Box 80002
5617 BA Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: [phone]
[email protected]
www.boschsecurity.com
Robert Bosch (SEA) Pte Ltd, Security
Systems
11 Bishan Street 21
Singapore 573943
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.asia
Bosch (Shanghai) Security Systems Ltd.
201 Building, No. 333 Fuquan Road
North IBP
Changning District, Shanghai
200335 China
Phone [phone]
Fax: [phone]
www.boschsecurity.com.cn
Robert Bosch Ltda Security Systems Division
Via Anhanguera, Km 98
CEP 13065-900
Campinas, Sao Paulo, Brazil
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
© Bosch Security Systems 2012 | Data subject to change without notice
1889273995 | en, V2, 24. Nov 2012