Bosch GCM 8 SJL User manual

Bosch GCM 8 SJL User Manual
14.03.2019

Safety Rules
Do NOT touch the saw blade
Do NOT wear gloves,
watches and jewellery
Cut only wood
Clean after usage
Use the ventilation

Terms
Slide
Blade Guard
Saw Blade
Material Clamp
HandleOn/Off Switch
Lock Switch
Slide Lock
Table Extension Clamps Miter Angle Lock
Miter Angle Scale
Table

Workpiece Holding
Always use the material
clamp to fix the workpiece
before cutting!
For longer workpieces, use the table extensions
NEVER hold the workpiece
with your hand close to the
saw blade!

Alignment
Use the laser to see where
the workpiece will be cut.
Laser Switch
The laser ray shows you the
left side of the final cut

Long cuts
Loosen the slider lock –you can now move the slieder
Start cutting at the front and push the handle towards
the end of the machine until your cut is completed
Cutting
Short cuts
Grab the handle with one
hand
Press the On/Off-switch and
the lock-switch
Push the handle down
slowly

Miter Angle
Open the miter angle lock
Press the miter detent lever
Rotate the table
Use the miter angle
indicator to set the required
angle
Close the miter angle lock
Miter Detent Lever
Miter Angle
Lock

Bevel Angle
Open the bevel clamping
lever
Adjust the bevel angle using
the bevel angle scale
Close the bevel clamping
lever
Bevel Clamping Lever
IMPORTANT: Move the adjustable fence to the left