Bosch DWBA68G60I User manual

Press the button for 3 seconds to enter the boost
and the button indicator will be blink. Boost will continue
10 minutes. After 10 minutes ,it will be go back previous
speed.
If the control panel printed with ,press the button
to enter the boost.Boost will continue 10 minutes.After
10 minutes,it will be go back previous speed.
U
,QWKDWFDVHWKHRWKHUIXQFWLRQVPXVWEHVWRSSHG
H[FHSWIRUODPSDQGWKHQDFWLYDWHVHOIFOHDQE\
SUHVVLQJWKHEXWWRQ U
U
U
WLPHLVH[SLUHGVHOIFOHDQPRGHZLOOEH
DXWRPDWLFDOO\
'XULQJVHOIFOHDQORQJSUHVV UWRVWRSVHOI
PRGH
The cycle for self clean mode is 9 minutes. When cycle
After a period of use, the button indicator will blink
to remind user that it's time to activate self clean mode.
If the button indicator does not blink, the other
U
functions of the hood are also closed (except for lamp),
at this time,press the button for 3 seconds, the button
Uindicator is on, and activate self clean mode.
3 seconds
3 seconds
clean
deactivated
3UHVVWKHEXWWRQ to cancel the reminder when the
indicator is blinking.
3UHVVWKHEXWWRQ DJDLQIDQZLOOEHRII
Press the button first time,the fan runs at the speed
1,the button indicator lighting and the button 1
indicator is on.
Press the button for 3 seconds to enter Delay Off
state for 10 minutes, the button indicator will be
blink and fan will runs at the speed 1.
When enter

filters

3456
Please follow the steps 1 / 2 / 3 / 4 / 5 / 6 shown in the
following figure to find the installation position of the
plate on the wall.
hood to ensure the exhaust pipe and the socket fixed
Fix the exhaust pipe to the pipe socket of the cooker
tightly.
Fix the mounting plate with M5x16 screw to prevent
the cooker hood falling off accidentally.
7U\WRDYRLGWKHXVHRIORQJH[KDXVWSLSHDVIDUDV
324mm

Ú,QVWDOODWLRQLQVWUXFWLRQV
Nail the expansion plastic plug into the wall.
Fix the valve seat with screws.
Put the multi-path joint on the valve seat,put
Fix the pipe with aluminum foil tape.
Aluminum Foil Tape
step 1 step 2 step 3
step 4 step 5 step 6
the exhaust pipe in the appropriate slot.
Instruction method:
step 1:
step 2:
step 3:
step 4:
step 5:
step 6:
Align the valve body with the smoke hole
on the wall.
Drill holes in the wall according to the hole
of valve seat.
CT