BOSSCO GT-6 User manual

Read This First
Achieving the Optimum
Settings for Your Setup
Your connections/Output Select settings need to be
configured so they’re appropriate for your operating
environment, as explained below.
To make settings for Output Select, press the OUTPUT
SELECT button to display the “Output Select” settings
screen, then rotate the PATCH/VALUE dial.
For more details, refer to p. 14 in the Owner’s Manual.
fig.001
* This is set to “COMBO AMP” when shipped from the factory.
* When using an amp with switchable channels, select the
NORMAL (CLEAN) channel. If the inputs are labelled L
and H, use L.
■When connecting to the Roland JC-120’s
NORMAL input
Output Select: JC-120
fig.002
■When connecting to a small practice amp
Output Select: SMALL AMP
fig.003
■When connecting to a combo amp’s
NORMAL input
Output Select: COMBO AMP
fig.004
■ When connecting to a stack amp’s NORMAL input
Output Select: STACK AMP
fig.005
■When connecting to a combo amp’s
RETURN or MAIN IN
Output Select: COMBO RETURN
fig.006
■When connecting to a stack amp’s RETURN
or MAIN IN
Output Select: STACK RETURN
fig.007
■When using headphones or conducting
recording (direct in)
Output Select: LINE/PHONES
■When connecting to a P.A. or mixer
Output Select: LINE (P.A.)
If You Want to Make Some Finer
Adjustments
You can adjust the tonal quality in the “GLOB: LowEQ” and
“GLOB: HighEQ” screens.
You can select these settings screens by pressing the UTILITY
button and then the PARAMETER buttons.
fig.008
For further details, refer to p. 59 in the Owner’s Manual.
INPUT
INPUT
INPUT
INPUT
RETURN
or
MAIN IN
RETURN or MAIN IN
Copyright © 2001 BOSS CORPORATION
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of BOSS CORPORATION.