mxr Hybrid Fuzz CSP041 User manual

Hybrid Fuzz
This pedal combines two iconic Fuzz Face®Distortion
sounds, featuring the snarling, high-gain aggression of
a silicon transistor and the smooth, shaggy warmth of
a germanium transistor in a single circuit.
CSP041
jimdunlop.com

CSP041 | MXR®Hybrid Fuzz 2
1OUTPUT knob adjusts volume level of effect
2FUZZ knob adjusts intensity of effect
3FOOTSWITCH toggles effect on/bypass (red LED indicates on)
2
External Controls
1
3

CSP041 | MXR®Hybrid Fuzz 3
Basic Operation
1. Run an instrument cable from your instrument to
the CSP041’s INPUT jack and another cable from the
CSP041’s OUTPUT jack to your amplifier.
2. Start with knobs set fully counterclockwise.
3. Turn effect on by depressing the footswitch.
4. Rotate OUTPUT knob clockwise to increase volume
or counterclockwise to decrease it.
5. Rotate FUZZ knob clockwise to increase intensity
of effect or counterclockwise to decrease it.
The MXR®Hybrid Fuzz is powered by one 9-volt battery
(remove bottom plate to install), a 9-volt AC adapter such
as the Dunlop ECB003/ECB003EU, or an MXR®Brick™
Series power supply.
Power Directions

CSP041 | MXR®Hybrid Fuzz 4
Specifications
Input Impedance > 15 kΩ
Output Impedance < 450 kΩ
Max Output Level -9.6dBU
Max Gain +42 dB
Noise Floor -87 dBU
Bypass True Hardwire
Current Draw 2.5 mA
Voltage Requirements 9 volts DC