Bosslan BOSST60 User manual

BOSST60 Quick Start Guide
Installation and access.......................................................................................................................2
Configure BOSST60 to make VoIP calls ..........................................................................................3
WAN Config .....................................................................................................................................3
SIP Config.........................................................................................................................................4

Installation and access
Installation:
Set up BOSST60 as below:
When the BOSST60 is connecting to your network.
You can use the “Sysinfo” button to obtain BOSST60 WAN port IP.
Modify your computer’s IP address to the same network as BOSST60
Key in BOSST60’s IP address in the web browser and press enter, then you can access
BOSST60’s web manage interface. Remember the account is admin/admin for administrator and
guest/guest for user.

Configure BOSST60 to make VoIP calls
WAN Config
Enter Network
Æ WAN Config to set the WAN setting:
BOSST60 supports three different IP types: Static IP, Dynamic obtain IP (DHCP) and PPPoE. You
can use either of these IP types to connect the internet.
Use Static IP:
----Select “Static”;
----Enter the BOSST60’s IP address in the “IP address” field.
----Set the “Netmask”, default 255.255.255.0
----Enter the BOSST60’s upper gateway IP address(for example:Router) in the “Gateway” field
----Key in the DNS information in the “Primary DNS” and “Alter DNS” fields.
Use DHCP:
----Select DHCP
If you have a DHCP server in your network, BOSST60 will automatically obtain the network
information from your DHCP server.
Use PPPoE:
----Select PPPoE
----Type your PPPoE dialup information in the PPPoE setting fields:PPPoE server(option),
Username and password.

Then the BOSST60 will connect to the internet through PPPoE , and automatically obtain the IP
address , Netmask, Gateway, Primary DNS and Alter DNS information.
SIP Config
Enter VoIP
Æ SIP Config setting page and set the sip information
----Register ServerAddr : sip server address;
----Register Server Port : sip serverre register port;
----Register Username : username of your sip account;
----Register Password : password of your sip account;
----Register Number : Phone number of your sip account; the same as username if none
----check Enable Register；
Then you can make VoIP calls if the WAN and SIP config is correct.
Notice: Please go to the “Config Manage” and save the config, otherwise you will lose the setting
after device reboot.