Bosswerk selfPV User manual

Quick Installation Guide
Easy Solar Kit
Step 1. Release mounting screws
Pick the Easy Solar Kit out of the package. Put it down slowly and
make the bracket upside. There are two mounting screws on the
bracket. Use a hex wrench (#5) to open the mounting screws as
shown below.
Step 2. Fix the bracket to the base plate
Lift up the base plate and the bracket. Screw on the mounting screws to
fix the bracket on the base plate as shown below.
Step 4. Adjust the angle of bracket
(optional)
Angle Lock is an optional function for Easy Solar Kit. There are two
angle locks on the bracket.
Step 3. Find a suitable location
Turn around the Easy Solar Kit and make the base plate downside.
Find
a suitable location and put down the Easy Solar Kit lightly. Adjust the
direction and make the solar panel facing the sunlight.
If neccessary the PV module can be separated from the micro-
inverter.
WARNING
WARNING
The bracket must be fixed on the base
plate, which will promote the wind
loading rating of Easy Solar Kit.
CAUTION Recommended angle parameters can
be found in the appendix table.
Please pay attention to the distance
between two ESK products and make
sure that there is no shadow over the
modules.
CAUTION
CAUTION
CAUTION
Please put the Easy Solar Kit on a flat and
non-shadowed location.
Easy Solar Kit has a 2m end cable and
should be set near the socket. Or use the
expansion cable as shown in Step 6.
Please adjust the direction at noon to get
a better electric energy production during
the day time.
Figure: Release mounting screws
Figure: Fix the bracket to the base plate
01 02 03
Figure: Put down the Easy Solar Kit
Figure: Angle lock on the bracket
Use a hex wrench (#5) to open the angle locks. Slowly put down the solar
panel and make the angle locks slip into the right angle. Then tighten the
angle locks again.
Figure: Adjust the angle lock
Figure: DC-plugs of PV module and micro-inverter

Base fasteners can be used to connect two base plates
together.
06
Bosswerk GmbH & Co. KG
Tel: [phone] - [email protected] |
www.greenakku.de Add - Herrenpfad 38, 41334 Nettetal,
Nordrhein-Westfalen, Deutschland
Step 8. Start the system
Insert the plug to the socket and the system will start producing
power after about a two-minute waiting time.
Step 7. Fix the base plate
Put weights (Brick, Stone etc.) on the base plate to promote the
wind loading rating of Easy Solar Kit.
CAUTION
Weights (Brick, Stone etc.) should be more than 20kg.
Or use base fasteners and nails to fix the base plate to the
ground.
Figure: Weights on the base plate
Figure: Optional accessories for the connection of base plate
Figure: Base fasteners and nails
04 05
Step 5. Extend the cable (optional)
Extension cable (GreenAkku ANW5,-10,-15,-20,-30) can be used
to extend the cable.
Disassemble the end cable.
Connect the two sides of extension cable to the
microinverter (AC) and the AC socket.
Abbildung: Schließen Sie das Verlängerungskabel an
Figure: Disassemble the end cable
Step 6. Install more Easy Solar Kit (optional)
More Easy Solar Kits can be connected together to form a whole
system.
Take out the end cable of the second Easy Solar Kit. Connect the two
sides of Extension Cable to the first and second microinverter.
Figure: Connect the Extension Cable