Boya BY-WXLR8 Pro User manual

1
BY-WXLR8 Pro
Plug-on Transmitter

2
For more details about LED indicator, please refer to “Power LED”
on page 30.
3) The pwer LED of BY-WXLR8 Pro blinks red when mute on.
Only works with XLR dynamic micrphones or battery-powered
condenser microphones.
1. Audio XLR input connector
Connect a microphone or a line output connector of an audio
mixer, etc.
2. Power LED
1) The power LED glows blue when the unit is on.
2) The power LED of transmitter glows red when low power.
NOTE:
3
4
5
6
7
2
8
9
Bagian-bagian

3
7. SET button
Press to change and enter display parameters.
For details, please see “How to set up channel, VOL, STEREO
and MONO” on page 24.
5. LCD display
8. Battery compartment
Accommodates two AA batteries.
6. + (+ selection)/ – (- selection) buttons
Press these buttons to set the transmission channel, or
attenuation level of the input signal.
9. Power/Mute button
Function Operation
Power ON
Power OFF
Mute ON
Mute OFF
Long press button
Long press button until it turns off
Short press button
3. Knurled ring
4. Line In
For more details, please refer to “LCD Display Operation Guide”
on page 30.
IMPORTANT
1. The BY-WXLR8 Pro doesnot supportexternal power supply.
2. Do not set the INPUT mold to MICmold while the audio signal
is being input from the audio mixer, etc., it may cause excessive
audio input, resulting indistroted playback or recorded sound or
damage to playback or recording equipment.

Press + & -
to unlock
5
4
5
4
LCD will be locked automatically in 30 seconds
Long press bottoms “+” and “-“ to unlock.
4
Cara Membaca Layar LCD
1 2 3
CH-A-48
①Channel Group (A/B）
Long press “SET” botton to change Channel “A” or “B”
②Channel number (1-48)
③Battery indication
Mute On

5
Memasang Baterai
The transmitter is each powered by two AA batteries. To install
batteries, please follow these steps:
1. Slide the battery cover to release the lock and open the battery
compartment.
2. Insert two new AA batteries into the battery compartment by
matching their polarities to the indications inside the compartment,
and then close the cover.

6
Memasang Mikrofon dan Kabel XLR
Microphone or XLR cable
Knurled ring
Push the microphone or cable connector into the XLR audio
input jack of the BY-WXLR8 Pro, then turn the knurled ring in a
anticlockwise direction,gently tightening it so the microphone or
XLR cable base is seated firmly in place.
To detach a microphone or a XLR cable
Turn the knurled ring in a clockwise direction, and pull off the
microphone or cable slowly.
Note: Please turn off the transmitter before attaching or removing
the microphone.
Connecting the Plug-on Transmitter and the Receiver
To connect the Plug-on Transmitter and the receiver, follow these steps:
1. Turn on the transmitter and the receiver.
2. Set the plug-on transmitter and the receiver to the same channel.
If you are experiencing interference or noise on one channel, try a
different channel.