Bradford White LT199NXX1 Quick guide

Installation and Instruction Manual
Pipe Cover
Model LT199NXX1 / LT199PXX1
LT199NRX1 / LT199PRX1
RTGS199N1 / RTGS199X1
RTGR199N1 / RTGR199X1
Installation and Instruction Manual S633100213 Rev 11/22

2
2
3
9
9
9
9
9
6
4
7
Included Pipe Cover Kit
Pipe Cover Kit Components & Dimension
44" [1120mm]
16.5" [420mm]
17.3" [440mm]
14.9" [380mm]
Part Shape Q’ty
1Front Cover 1
2Left Plate 1
3 Right Plate 1
4 Front Cover Bracket 1
5 Case Bracket 2
1
10
Part Shape Q’ty
6 Frame Bracket 1 2
7Frame Bracket 2 1
8Dry Wall Anchor 2
9Screws (M4x10L) 12
10 Knob 1
11 Installation Instruction 1

3
1. Pre-Assemble Frame before installation
2. Install Pipe Cover onto Water Heater
1) Assemble the Front Cover Bracket (
④
) to the
one of the Frame Bracket 1 (
⑥
).
2) Assemble this Frame Bracket 1 (
⑥
) assembled
Front Cover Bracket (
④
) to the Left and Right
Plate (
②,③
) with Screws-M4x10L (
⑨
).
3) Secure the two Frame Brackets 1, 2 (
⑥,⑦
) to
the Left and Right Plate (
②,③
) with Screws-
M4x10L (
⑨
).
1) Remove the mounting 4 screws (A) from the
bottom and sides of the appliance. Refer to
Figure 1.
2) Install the two Case Brackets (
⑤
) to the bottom
of the appliance with the 4 screws (A) removed
in the previous step. Refer to Figure 2.
3) Slide the Pipe Cover assembly onto the bottom
of the appliance. Align the mounting holes and
temporarily mount the Pipe Cover with the 4
Screws-M4x10L (
⑨
). Refer to Figure 3.
4) The 'back' bottom Frame Bracket 1(
⑥
) inserts
into the temporarily mounted Pipe Cover. Mark
the locations to attach the Pipe Cover to the wall
onto the 'back' bottom Frame Bracket 1(
⑥
).
5) Remove the Pipe Cover from the wall and
then drill two holes on the wall as marked.
For drywall, drill two 3/16-in. holes (other
wall materials will require alternate mounting
methods).
5
A
A
A
A
5
Figure 1
Figure 2
2
3
9
9
9
9
9
9
6
4
7
6
Installing the Pipe Cover

4
6) Attach 'back' bottom Frame Bracket 1(
⑥
) to
the wall with two dry wall anchors (
⑧
). Refer
to Figure 4.
7) Attach the pre-assembled Pipe Cover onto
the bottom of the appliance. Tighten the 4
Screws-M4x10L (
⑨
) on the both sides of pre-
assembled Pip Cover.
8) Attach the Front Cover (
①
) to the Pipe Cover
with the Knob (
⑩
). Refer to Figure 5.
9) With the Pipe Cover ush with the appliance,
tighten the screws on the bottom Frame
Bracket 1(
⑥
) see Figure 5.
Figure 3
Figure 4
Figure 5
9
8
10
1
8
9
9
6