Brainwavz EARPAD ADAPTER ring FOR Corsair Virtuoso RGB... User manual

EARPAD ADAPTER ring FOR Corsair Virtuoso RGB Wireless
Installation GUIDE
Remove Stock Pads
Grip the pad
firmly with thumbs
and fingers.
1
Twist the pad to the right
(clockwise) to release the pad
from the head unit.
NOTENOTE : The pads are attached
to a plastic mounting ring
2
Get To Know The Adapter Ring
V
I
R
T
U
O
S
O
FRONTFRONT BACKBACK
A
There are 3 raised
clips A that fit
into corresponding
holes on each
headset
The smooth back
panel sits flat
against the inside
of your chosen
earpad.

Install The Earpads
Install The Adapter
Line up the three clips on the adapter ring A with the three
holes on the head unit B , and slot the pad into place.
Ensure all three clips are in correctly before continuing.
Grip the plastic ring and pad
together and slowly but firmly twist
10 - 15 degrees to the left (counter
clockwise).
2
1
✔
✘
AB
Slide the adapter
into the mounting
flap on the rear of
the earpad, pull the
fabric over so the
ring is completely
inside the flap
Ensure that the
fabric flap does not
obstruct any of the
mounting clips
NOTENOTE
Do not over-tighten
or you may break the
mounting clips.