Brandt VH1772X User manual

9
11
15
15
15
17

is 12

cycle and operate the dishwasher according to the original Power-on state.
If the appliance is switched off during a wash cycle, when switched on again, please re-select the washing
Scrap off any large amount of leftover food.
Soften remnants of burned food in pans, and then load the baskets.
Refer to the section entitled “Preparing and Loading Dishes”.
Turn on the water tap. The appliance will start working after 10 seconds.
1.Press the start/pause button to stop the washing.
2.Open the door a little.
3.After the spray arms arm stop working, you can open the door completely.
4.Add the forgotten dishes.
5.Close the door.
6.Press the start/pause button, the dishwasher will run after 10 seconds.
1.A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.Press the start/pause button to stop the washing, and then press the program button for more than 3
seconds to cancel the sunning program.
3.Select a new program.
4.Restart the dishwasher.
When the working cycle has finished, it stops. Turn off the appliance using On/Off button.

1.On/Off Button: To turn on/off the power supply.
!"#$$%&
4
6
7.Extra drying Button and indicator: Press the button to
select the Extra drying function.
Meanwhile, the indicator will light.
6.Delay time or error codes indicator.
2.Program Button: Press the button to select a wash
program.
3.Half load function Button and indicator: Press the
Button to select Half load function. To be selected only
with 6 place-setting or less. This option will lead to lower
water and energy consumptions. Please note that with glass
and soak program, half load function cannot be selected.
4.Program indcator and program icons:
To indicates which program has been selected.
P1:Indicates
P2:Indicates
P3:Indicates
P4:Indicates
P5:Indicates
P6:Indicates
P7:Indicates
has been selected
has been selected
has been selected
has been selected
has been selected
has been selected
has been selected
• Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not recommended
• Washing tableware in a household dishwasher usually consumes less energy and water in the use phase than hand
dishwashing when the household dishwasher is used according to the manufacturer’s instructions.
—
—
—
—
—
—
—
5.Rines aid warning indicator
Salt aid warning indicator
They indicate when the corresponding dispenser needs
needs to be filled.
8.Delay Button:To delay the start of a washing program.
9.Start/Pause Button:To start the selected
washing program or pause the washing program
when the machine is working.
ECO
Universal.

1. C lose the door and switch on the appliance;
2. Press the Program button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on;
3. Press the Program button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
Please follow the steps below for adjustment in salt consumption.
k