Braun HC 50N-R Operating instructions

Series
Hair perfect
www.braun.co.jp
HC 50N-R
HC 20N-R
charge
h
a
i
r
p
e
r
f
e
c
t
oil
2
1345678
charge
99405934_HC50_Japan.indd 199405934_HC50_Japan.indd 1 12.02.2010 13:00:38 Uhr12.02.2010 13:00:38 Uhr
Booklet, 105x148 mm, 24 pages, 2/2c = black + PMS541u

2
99405934_HC50_Japan.indd 299405934_HC50_Japan.indd 2 12.02.2010 13:00:39 Uhr12.02.2010 13:00:39 Uhr

3
99405934_HC50_Japan.indd 399405934_HC50_Japan.indd 3 12.02.2010 13:00:39 Uhr12.02.2010 13:00:39 Uhr

4
99405934_HC50_Japan.indd 499405934_HC50_Japan.indd 4 12.02.2010 13:00:39 Uhr12.02.2010 13:00:39 Uhr

5
99405934_HC50_Japan.indd 599405934_HC50_Japan.indd 5 12.02.2010 13:00:39 Uhr12.02.2010 13:00:39 Uhr

6
99405934_HC50_Japan.indd 699405934_HC50_Japan.indd 6 12.02.2010 13:00:39 Uhr12.02.2010 13:00:39 Uhr

7
charge
h
a
i
r
p
e
r
f
e
c
t
2
13
oil
45678
| trim
off| |on
charge
OIL
99405934_HC50_Japan.indd 799405934_HC50_Japan.indd 7 12.02.2010 13:00:42 Uhr12.02.2010 13:00:42 Uhr

8
99405934_HC50_Japan.indd 899405934_HC50_Japan.indd 8 12.02.2010 13:00:43 Uhr12.02.2010 13:00:43 Uhr

9
99405934_HC50_Japan.indd 999405934_HC50_Japan.indd 9 12.02.2010 13:00:43 Uhr12.02.2010 13:00:43 Uhr

10
99405934_HC50_Japan.indd 1099405934_HC50_Japan.indd 10 12.02.2010 13:00:44 Uhr12.02.2010 13:00:44 Uhr

11
99405934_HC50_Japan.indd 1199405934_HC50_Japan.indd 11 12.02.2010 13:00:44 Uhr12.02.2010 13:00:44 Uhr

12
99405934_HC50_Japan.indd 1299405934_HC50_Japan.indd 12 12.02.2010 13:00:44 Uhr12.02.2010 13:00:44 Uhr

13
7
8
oil
oil
oil
oil
99405934_HC50_Japan.indd 1399405934_HC50_Japan.indd 13 12.02.2010 13:00:44 Uhr12.02.2010 13:00:44 Uhr

14
99405934_HC50_Japan.indd 1499405934_HC50_Japan.indd 14 12.02.2010 13:00:44 Uhr12.02.2010 13:00:44 Uhr

15
99405934_HC50_Japan.indd 1599405934_HC50_Japan.indd 15 12.02.2010 13:00:45 Uhr12.02.2010 13:00:45 Uhr

16
99405934_HC50_Japan.indd 1699405934_HC50_Japan.indd 16 12.02.2010 13:00:45 Uhr12.02.2010 13:00:45 Uhr

17
oil
oil
oil
clean & oil D
AB
C
charge
h
a
i
r
p
e
r
f
e
c
t
2
13
oil
45678
| trim
off| |on
12
11
13
oil
10
1
2
6
7
8
3
4
5
9
99405934_HC50_Japan.indd 1799405934_HC50_Japan.indd 17 12.02.2010 13:00:47 Uhr12.02.2010 13:00:47 Uhr

18
English
Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Warning
Keep the appliance dry.
Do not use the clipper near or over basins filled with water
(e.g. bath tubs, showers etc.).
Do not wind the cord around the appliance.
For household use only.
When the distance comb is removed, the cutting system should not be
pressed into the skin. Danger of injury!
After each use, clean and oil the cutting system (D).
This appliance is not intended for use by children or persons with reduced
physical, sensory or mental capabilities, unless they are given supervision
by a person responsible for their safety. In general, we recommend that
you keep the appliance out of reach of children. Children should be
supervised to ensure that they do not play with the appliance.
Your shaver is provided with a special cord set with integrated Safety
Extra Low Voltage power supply. Therefore you must not exchange or
manipulate any part of it. Otherwise there is a risk of electric shock.
Description
1 Distance comb
2 Cutting system
3 Release button for cutting system
4 Length settings
5 Length selector
6 On/off switch
7 Pilot light (HC 50 only)
8 Cord socket
9 Special cord set
10 Barber’s comb
11 Barber’s scissors
12 Light machine oil
13 Cleaning brush
Technical specifications
Power supply: 100–240 V~ / 50–60 Hz
Wattage: 7 W
•
•
•
•
•
•
•
•
99405934_HC50_Japan.indd 1899405934_HC50_Japan.indd 18 12.02.2010 13:00:52 Uhr12.02.2010 13:00:52 Uhr

19
Charging the clipper (HC 50 only)
When charging for the first time or when the appliance is not used for a few
months, leave the appliance to charge continuously for 4 hours.
The charging light shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged. Once the clipper is completely charged, use it without the cord
until discharged. Then recharge to full capacity again (1 hour).
A full charge will give up to 30 minutes of cordless trimming depending on
your hair. However, the maximum capacity will only be reached after several
charging/discharging cycles.
Best environmental temperature range for charging is 15 °C to 35 °C.
If the rechargeable battery is discharged, you may also operate the clipper
via the mains cord. (If the clipper does not run immediately, charge it for
approx. 1 minute in the «off» position.)
General
The person whose hair you want to cut should sit in a position where the top
of the head is at your eye level.
The hair should be clean, well combed, tangle-free and dry.
Ensure you have a firm, but relaxed grip on the clipper.
If you are not used to clipping hair, begin with a higher setting and then
reduce the setting to avoid cutting more hair than desired.
Use a slow and controlled movement. Do not force the clipper through
the hair faster than the clipper can cut it.
In between, shake or blow off the hair from the clipper. If too much hair
is caught in the distance comb, remove and clean it.
To control your progress during clipping, regularly comb the hair in the style
desired.
Normal clipping
Push the distance comb (1) onto the hair clipper until it locks. The hair length
selector (5) must be in position «1».
To choose the desired length setting (4), push down the length selector and
shift it upward. To start clipping, shift the on/off switch (6) to «on».
99405934_HC50_Japan.indd 1999405934_HC50_Japan.indd 19 12.02.2010 13:00:52 Uhr12.02.2010 13:00:52 Uhr

20
Keep the distance comb flat on the hair, parallel to the head, and slowly
move against the direction of hair growth. The distance comb can only be
taken off when the length selector is set to «1».
Clipping or trimming without distance comb
Remove the distance comb (only possible at setting «1»). To start clipping,
shift the on/off switch to «on».
Move the cutting system only in a parallel position to the skin (A, cutting
hair). Slowly and carefully move the appliance against the direction of
hair growth. Only when trimming contours should the cutting system be
positioned vertically (B, trimming).
Make sure you do not tilt the appliance while it is touching the skin (C).
Avoid jerky movements while cutting.
Clipping with the barber’s comb
To cut longer hair, hold it up with the barber’s comb (10) and cut it with
the scissors (11) or with the clipper (distance comb must be removed from
the clipper – only possible at setting «1»).
Keeping your clipper in top shape
After each use and when the distance comb is taken off, slightly shake
or brush hair from the clipper and the distance comb. Press the release
button (3) to open the cutting system (2). Using the brush (13), clean the
cutting system and the inside of the clipper.
To keep the cutting system working properly, oil it with light machine oil after
each use (D).
Then click the cutting system back to its original position.
After use, unplug the cord from the appliance for longer cord life.
Preserving the rechargeable battery (HC 50 only)
In order to optimise the capacity and life of the battery, it should be fully
discharged through regular use every 6 months approximately. Then
recharge to full capacity again. Do not keep the clipper on permanent
charge. Do not expose the clipper to temperatures of more than 50 °C for
longer periods of time.
99405934_HC50_Japan.indd 2099405934_HC50_Japan.indd 20 12.02.2010 13:00:52 Uhr12.02.2010 13:00:52 Uhr