brel-motors DC-50 User manual

BREL motors is part of: Page 1
Manual Brel receiver
Type DC-50
Read the manual before you begin the installation. If these instructions are not followed,
this may lead to defects and injury in which warranty can’t be claimed.
____________________________________________________
Technical specifications Type DC-50
•Voltage: 230V
•Power: 900W
•Speed: 20cm/sec.
•Amperage: 4A
•Radiofrequency: 433.92MHz
•Moisture and dust: IP55
•Working temperature of the motor:
oNormal use: -10℃tot +40℃
oHeavy use: -20℃tot +70℃
____________________________________________________
Button specifications
Up
Channel- Channel+ P2 Mode
Down Time
Operates with these BREL motors and receiversː
Motors: MR, MEV, MCE, MDE, MLE, MJE, MTE, MEQ.
Receivers: DC-50, DC-90, DC-92, DC-94, DC-101, DC-109, DC-114, DC-227, DC-252,
DC-253, DC-292, DC-305, DC-306, DC-2702.
____________________________________________________
Functions Reach
L1 = 100 meter L2 = 25 meter
If in the 5 channel receiver all
the lights are lid. All the
products are operated
simultaneously. (mode and
time have only a function on an
emitter with a timer).
on an
emitter with a timer)

Page 2
____________________________________________________
Installation receiver
The long white wire is the antenna and may not be connected to the electricity.
Make sure that no moisture can run into the receiver.
____________________________________________________
Wiring chart
____________________________________________________
Teaching multiple transmitters
2xP2 1xP2
Press 2x the P2 Press 1x the P2 The programming of the
Button. (a) button. (b) new transmitter is ready.
To delete one channel , you must repeat the above operation.
____________________________________________________
Reset all
1x P2 1x STOP 1x P2
Press P2 button 1x. Press STOP button 1x. Press P2 button 1x. All channels are removed
____________________________________________________
The pulse setting
1x P2 1x 1x
The motor is
ready for use.
Press P1 button 1x Press up button 1x Press down button 1x
To remove the pulse setting, repeat the above operation.