BROKIS MACARON PC1038 User manual

CM12213

MACARON
Table light, Floor light
1x base (bottom section with power cable)
1x light source GX53
1x bottom and top glass sections
1x centre plate (stone/glass)
1x cotton gloves
1x installation manual
The manufacturer assumes no liability
for damage resulting from incorrect
assembly. When unpacking the light, do
so with regard for its material
composition – the main components are
made of glass.
Wear the cotton gloves included with the
light when unpacking and assembling it.
INSTALLATION
MANUAL
COMPONENTS OF
PACKAGING:
WARNING:
Instalation time: 10 minutes / 1 person
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 2
Download

CLEANING THE GLASS
BROKIS applies the highest possible quality standards in manufacturing its lights. Prior to shipping, each light
undergoes several quality controls and stages of cleaning. Lights may require additional cleaning as a result of
transportation, storage, and the amount of time that passes between packing in our plant and subsequent
unpacking by the client. Therefore, we emphasizes cleaning the lights prior to installation.
The glass must first be rinsed in hot water, with a dilution of a dish-detergent used to remove all foreign
particles and dust. Eventually repeat this basic treatment, if necessary. Afterwards the glass must have a second
cleaning using hot water, with a dilution of a de-greaser (such as ammonia or vinegar). The glass must then be
thoroughly rinsed with running hot water. Eventually repeat this treatment, if necessary. The glass is then
thoroughly dried with a paper towel or a clean soft cotton towel. Only re-assemble the glass to the lamp body,
when completely cooled down.
Do not use mineral spirits, highly concentrated thinners, or other substances not intended for use on glass
surfaces. Also: do not use products, containing silicones – since they will rapidly attract more dust and grease.
PRIOR TO SHIPPING, THE FUNCTIONALITY OF EACH LIGHT AND ITS COMPONENTS IS THOROUGHLY TESTED.
THE MANUFACTURER ASSUMES NO LIABILITY FOR THE MISHANDLING OF PRODUCTS.
MACARON
Table light, Floor light
INSTALLATION
MANUAL
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 3
Cleaning information

Install the GX53 light source in the base. Position the bottom glass section on the base. Ensure the glass is correctly
aligned.
ASSEMBLING THE LIGHT 1/3
1.
PAGE 4

Carefully position the centre plate on the bottom glass section. The glass must fit precisely into the groove in the stone plate
(smaller diameter groove).
ASSEMBLING THE LIGHT 2/3
2.
PAGE 5

Position the upper glass section on the light.
ASSEMBLING THE LIGHT 3/3
3.
PAGE 6

Plug the power cable into an electrical outlet and ensure the light works properly.
SWITCHING ON THE LIGHT
4.
PAGE 7