BROKIS Ivy Floor User manual

IVY
Floor light
1x IVY light
1x IVY base
1x power cable
7x LED light sources
7x glass shades
1x pair cotton gloves
1x installation manual
1x hex key size 1.5
The manufacturer assumes no liability for
damage resulting from incorrect assembly.
When unpacking the light, do so with regard
for its material composition – the main
components are made of glass.
Wear the cotton gloves included with the light
when unpacking and assembling it.
INSTALLATION
MANUAL
COMPONENTS INCLUDED
WITH UNIT:
WARNING:
Installation time: 20 minutes / 1 persons
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 2
Download

CLEANING THE GLASS
BROKIS applies the highest possible quality standards in manufacturing its lights. Prior to shipping, each light
undergoes several quality controls and stages of cleaning. Lights may require additional cleaning as a result of
transportation, storage, and the amount of time that passes between packing in our plant and subsequent
unpacking by the client. Therefore, we emphasizes cleaning the lights prior to installation.
The glass must first be rinsed in hot water, with a dilution of a dish-detergent used to remove all foreign
particles and dust. Eventually repeat this basic treatment, if necessary. Afterwards the glass must have a second
cleaning using hot water, with a dilution of a de-greaser (such as ammonia or vinegar). The glass must then be
thoroughly rinsed with running hot water. Eventually repeat this treatment, if necessary. The glass is then
thoroughly dried with a paper towel or a clean soft cotton towel. Only re-assemble the glass to the lamp body,
when completely cooled down.
Do not use mineral spirits, highly concentrated thinners, or other substances not intended for use on glass
surfaces. Also: do not use products, containing silicones – since they will rapidly attract more dust and grease.
PRIOR TO SHIPPING, THE FUNCTIONALITY OF EACH LIGHT AND ITS COMPONENTS IS THOROUGHLY TESTED.
THE MANUFACTURER ASSUMES NO LIABILITY FOR THE MISHANDLING OF PRODUCTS.
IVY
Floor light
INSTALLATION
MANUAL
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 3
Cleaning information

Wear the cotton gloves when unpacking the light.
1. Insert the metal light (branch) into the connector in the base.
2. Turn the cap to tighten it.
3. Lock the cap in place by tightening the set screw with the 1.5 hex key.
ASSEMBLING THE LIGHT
1.
PAGE 4

Install the LED light sources in the fixtures. Next, screw the glass shades in place.
INSTALLING THE LED LIGHT SOURCES AND GLASS SHADES
2.
PAGE 5

Insert the connector on the power cable into the connector on the light.
Plug the power cable into an electrical outlet and test the light.
CONNECTING THE LIGHT
3.
PAGE 6

To uninstall the light, follow the above installation steps in reverse order.
DIASSEMBLING THE LIGHT
4.
PAGE 7