Board Diagram
Please follow the following step
Please check the following items before installation. If any missing, please contact the dealer.
PoE Ethernet Repeater 1 pcs
MIT 2 pcs
1 pcs
Hangers
User Manual
1)
device;
2) Check if the network cable and other transmission line that will be used is occupied by other device;
3) Use a network cable to connect PoE Ethernet repeater's POE IN port with PoE Ethernet switch;
4) Use 2 network cables to connect 2 PoE IP camears with PoE Ethernet repeater's PoE output port
respectively
5) Check if the installation is correct and device is good, make sure all the connection is reliable and
power up the system;
6) Make sure the network is normal.
Please turn off the signal source and the device's power, installation with power on may damage the
Installation Steps
It is a PoE Ethernet repeater, which uses advanced network cable drive and power supply
technology to extend 100M Ethernet signal to 300 meters, greatly extending the transmission
distance and providing PoE at the same time. It is widely used in security surveillance and
network project.
Feature
Provide 3x 10/100Mbps Ethernet ports, one PoE input port, two PoE output ports, which
can meet the requirements of local monitor, long distance transmission and PoE power
supply;
Use advanced net work cable drive technology, the longest distance up to 300m;
PoE power supply is compatible with End-Span and Mid-Span;
Meet standards of IEEE802. 3 10BASE-T, IEEE802. 3u 100BASE-TX, IEEE802. 3af/at;
Excellent circuit isolation protection, effectively improve product's lightning protection,
ESD and anti-interference ability;
Appearance and structure: solid and delicate, easily install on the wall and desktop;
Operation: plug and play, no setting required.
PoE
Ethernet Repeater
Notice
12
Please use standard Cat 5e/6 cable to get the longest transmission distance！
PoE Ethernet Repeater
Instruction:
Right side
CAT5e/6
PoE IP Camera
PoE Ethernet Repeater
PoE Ethernet Switch
150m
150m
PoE IP Camera
Left side
Output Port
PoE OUT PoE OUT
Output PortGrounding
Terminal
PoE IN
Input Port
Device must be connected with lightning protection grounding; otherwise protection level
will reduce; please use above No.20 wire to connect the grounding terminal.
Notice：
Application
BRX401-EPSR
