Bulldog Security TR25 User manual

TR25
Quick Start Guide
The Bulldog Tracker can be directly connected to a vehicle with a power
output of 12 - 24V.
Connect the BLACK wire to the battery negative, chassis or other
ground point.
Connect the RED wire to the battery positive or other un-switched
positive wire.
Do not mount the Tracker in the engine bay or other area where it can
get wet; next to radio equipment; between metal cavities in the vehicle
or other parts of the vehicle where interference may be caused such as
radio speakers. These instructions are for a negative earth vehicle..
INSTALLATION
Your Bulldog Tracker has a SIM card inserted in it and you will need to
register this SIM card and your tracker to allow you to use it.
To register please visit:
www.bulldogtracking.co.uk/register
During the registration you will need your SIM Serial Card Number and
the Tracker IMEI Number. These can be found on the card with the
tracker.
Once registration is confirmed, your Bulldog Tracker can be tracked via
smartphone app or website.
Smartphone app: Visit your app store, search and download GPS
Tracker MS03. Enter the User Account and Password as chosen..
Website: Visit http://track.bulldogtracking.co.uk Use the same log in
details as the smartphone app.. Use the smartphone app for all
tracking on a phone or tablet.
REGISTER & TRACK
BULLDOG SHALL IN NO EVENT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, CONSEQUENTIAL OR
PUNITIVE DAMAGES OR FOR LOSS, DAMAGE, OR EXPENSE, INCLUDING LOSS OF USE, PROFITS, REVENUE,
OR GOODWILL, DIRECTLY OR INDIRECTLY ARISING FROM PURCHASER’S USE OR INABILITY TO USE THE
PRODUCT, OR FOR LOSS OR DESTRUCTION OF OTHER PROPERTY OR FROM ANY OTHER CAUSE, EVEN IF
BULLDOG HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. BULLDOG SHALL HAVE NO
LIABILITY FOR ANY DEATH, PERSONAL AND/OR BODILY INJURY AND/OR DAMAGE TO PROPERTY OR
OTHER LOSS WHETHER DIRECT, INDIRECT, INCIDENTAL CONSEQUENTIAL OR OTHERWISE, BASED ON A
CLAIM THAT THE PRODUCT FAILED TO FUNCTION.
THE TRACKING SERVICE ASSOCIATED WITH THE BULLDOG TRACKER IS PROVIDED BY A THIRD PARTY AND
AS SUCH BULLDOG SHALL IN NO EVENT BE LIABLE FOR THE SERVICE PROVIDED INCLUDING, BUT NOT
LIMITED TO, THE AVAILABILITY, ACCURACY, FUNCTIONALITY OR SUITABLIBITY AND MAY BE WITHDRAWN
AT ANY TIME, WITHOUT NOTICE.
THE SIM CARD INSTALLED IN THE BULLDOG TRACKER IS PROVIDED BY A THIRD PARTY AND AS SUCH
BULLDOG SHALL IN NO EVENT BE LIABLE FOR THE SERVICE PROVIDED INCLUDING, BUT NOT LIMITED TO,
NETWORK AVAILABILITY, FUNCTIONALITY OR SUITABLIBITY AND MAY BE WITHDRAWN AT ANY TIME,
WITHOUT NOTICE. USE OF THE SIM CARD IN THE BULLDOG TRACKER IS SUBJECT TO THE TERMS AND
CONDITIONS OF THE PROVIDER, GPS|SIMCARD, AND SUCH TERMS CAN BE VIEWED AT
GPSSIMCARD.CO.UK/TERMS . THE SIM CARD IN THE BULLDOG TRACKER REQUIRES REGISTRATION AND
DETAILS ARE PROVIDED AT WWW.BULLDOGTRACKING.CO.UK/REGISTER
Bulldog Security Products Ltd, Units 1-4 Streon Road. Much Wenlock. Shropshire. TF13 6DH
Customer Service:
01952 728171
www.bulldogtracking.co.uk
Version 2

To set a speed alert to notify you if the tracker moves, press the menu
icon:
Fig 4. Press Management, then Command
Fig 5. Select Set the speeding alarm
Fig 6. In the Speed Limit box enter a speed (in km/h) over which you
want to receive a push notification in the event of this speed being
exceeded. Press the Tick in the top right corner.
Fig 7. If the command is successful a success message will be
displayed - Send successfully
When your tracked asset exceeds the set speed limit, a push
notification will be shown on your smartphone
To disable the speed alert, proceed as above but in the Speed Limit
box, enter 0
If you receive an error message such as Tracker Offline, try again later.
SET UP SPEED ALERT
PUSH NOTIFICATIONS
To receive push notifications, you must ensure that they are enabled in
your tracking app.
Fig 1. Press Settings
Fig 2. Push notification
Fig 3. Tap the slider on Push notifications (3a), select All (3b), then
press the Tick (3c)
Or only select Low Battery and Start Moving.
If you do not receive any push notifications ensure that the MS03 app is
permitted to send push notifications within your iOS or Android setting.
Fig. 4 Fig. 5 Fig. 6
Fig. 7
3c
3a
3b
Fig. 1 Fig. 2 Fig. 3
Whilst changing settings in the screen shown in Fig 2. ensure that the
following are set:
Distance Unit: Mile
GPS Invalid: Show last GPS location
Upon Logging in, swipe left and select your tracker. The app will
now show its location on the map.